Wandunia & Thomas wrote:
This is the first time I try installing anything without a detailed step by
step guide, so I'm probably doing something wrong:
I downloaded the tree and untared it.
I switched to the root directory of the untared files and tried "make
install" (after "su"). Then I rebootet, but my card still isn't recognised.
In dmesg the last card on the "known cards" list is still #50 - not 56, and
my card shows up as unknown.
Then I tried "make" and then "make install" again (creating a lot of new
files in the %/v4l subdirectory that I probably don't need?). I switched to
the v4l subdirectory and did the same commands. But even though the
installation looks ok (I don't get any errors) the card is still nocd t
recognised.
What should I do to get my card working?
Download the hvr1300 tarball.
Unpack it.
As root cd to the root of the unpacked directory.
# make clean
# make distclean
# make
At this point make sure you do not have any build errors. The entire
build process take around 120 seconds on my pc.
If the build finishes without error,
# make unload
# make install
# make load
At this point the card should be recognised if everything has
built/installed correctly.
The procedure is described here:
http://www.linuxtv.org/repo/
Regards,
Steve
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
