Hi, I confirm that my KNC1 DVB-C Plus card works with the CI module. I had to change the driver code to allow initializing CI event if it sees a saa7113 chip. I was then able to descramble channels with an ASTON VIACCESS CAM module. I did not test the S-Video input. Le Jeudi 29 Juin 2006 00:24, Andrew de Quincey a écrit : > On Wednesday 28 June 2006 23:20, Bastian Friedrich wrote: > > Hi, > > > > On Wednesday 28 June 2006 23:40, you wrote: > > > Looking at the most likely card on KNC1.com, the problem is the card > > > supports analogue inputs *AND* a CI module. > > > > In fact the card probably does support some analogue input via a S-Video > > connector. I don't have the slightest idea why I should want this, but > > anyway... I have it ;) > > > > I was (obviously falsely) believing that the difference between the > > Plus- and non-Plus cards was the existence (or non-existence, > > respectively) of a CineView connector, but yes, the Plus version has > > some analogue _and_ a CI connector. > > > > > Previous cards didn't > > > support this, so the driver is set up to assume if it sees an saa7113 > > > chip (for the extra inputs), then the card cannot have a CI module. > > > > Well... This is no longer true :( > > > > > This would have to be investigated by trying combinations out to see > > > what works - or else by asking the manufacturer for information. > > > > If there is any additional help I can provide - I'll be glad to help :) > > I'm trying to find out if I can get info... > > Also, I might be able to figure it out if I had remote ssh access to the > card for a while to see if I can work out what is needed. > > _______________________________________________ > > linux-dvb@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb _______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb