Re: New budget-ci type wasn't found ??

[dan <dan@xxxxxxxxx>]

Hi Peter


I think the answer for your problem is somewhere around:
http://www.linuxtv.org/pipermail/linux-dvb/2006-February/008610.html

Also have a look here about "high voltage mode" i.e. LLC flag for this card:
http://www.linuxtv.org/pipermail/linux-dvb/2006-February/008417.html
(It seems that Technotrend recommends to set the LLC bit
always to "1" otherways it mess up the tune part.)


Hope it helps.

Dan
//

Peter Maersk-Moller wrote:
> Hi Dan.
>
> Yes, it is in fact the S-1500 from TT. It matches the image 100%.
> However the device type is 0x1017 and not 0x100c.
>
> The card is sold as a Hauppuage WinTV Novia-ci-s by dvbshop.net.
>
> I tried to modify budget-ci.c to recognize type 0x1017 as a type
> 0x100c and the driver then load the card. However when I try
> tuning the card, the tuner hangs for 6-8 seconds before returning
> an error. Maybe the tuner is wrong, but I can't read the damn
> small lettrs on the tuner chip.
>
> # dvbtune  -c 1 -f 11388000 -p H -s 27500
> Using DVB card "ST STV0299 DVB-S"
> tuning DVB-S to L-Band:-1209305000, Pol:H Srate=27500000, 22kHz=off
> ERROR setting voltage
> : Remote I/O error
> ERROR setting tone
> : Connection timed out
> polling....
> Getting frontend event
> FE_STATUS:
>
> Also measured the signals for the LNB. None are present, so somehow the
> voltage for the LNB doesn't gets turned on
>
> Any suggestions ? Anybody who know the exact tuner type ?
>
> Kind regards
>
> dan wrote:
> > Hi,
> >
> > It seems your card is made by Technotrend (model TT-budget S-1500).
> > (Technotrend Systemtechnik GmbH: Unknown device 1017)
> >
> > Have a look at:  http://shop.technotrend.de to see if it similar to 
> > yours.
> > If this is the card the there was some discussion on this list a 
> > while ago.
> > (starting january this year).
> >
> >
> > Dan
> >  **
> >
> >
> > Peter Maersk-Moller wrote:
> >
> > > Hi.
> > >
> > > I have just bought a couple of new type Hauppauge Nova-ci-s cards 
> > > from DVBShop,
> > > but the cards doesn't seems to get installed. The old device types 
> > > (100f) does
> > > gets installed, but the new one (device type 1017) is missing. Is there
> > > an easy way to fix that ?
> > >
> > > Here are the differences between old (working) boards and the new one
> > >
> > > Old:
> > >
> > >   PCB boardcolor : orange/brown
> > >   PCB boardname : B2S1100
> > >
> > > New
> > >   PCB boardcolor : green
> > >   PCB boardname : B2S2000
> > >   PCB extra text : TT2004.33
> > >   Code on tunercabinet : 19300433
> > >
> > > The board has been redesigned and seems to have a new larger 
> > > LNB-power-chip.
> > > Probably because the older cards dies after been turned on continously
> > > for 6-12 months.
> > >
> > > Kind regards
> > >
> > > --PMM
> > >
> > > Kernel is 2.6.10.
> > >
> > > >From syslog
> > > Apr 28 13:16:39 satrec12 kernel: saa7146: unregister extension 
> > > 'budget_ci dvb'.
> > > Apr 28 13:16:44 satrec12 kernel: saa7146: register extension 
> > > 'budget_ci dvb'.
> > > Apr 28 13:16:44 satrec12 kernel: saa7146: found saa7146 @ mem 
> > > e087e000 (revision 1, irq 18) (0x13c2,0x100f).
> > > Apr 28 13:16:44 satrec12 kernel: DVB: registering new adapter 
> > > (TT-Budget/WinTV-NOVA-CI PCI).
> > > Apr 28 13:16:44 satrec12 kernel: adapter has MAC addr = 
> > > 00:d0:5c:23:ca:84
> > > Apr 28 13:16:44 satrec12 kernel: budget_ci: CI interface initialised
> > > Apr 28 13:16:44 satrec12 kernel: DVB: registering frontend 0 (ST 
> > > STV0299 DVB-S)...
> > > Apr 28 13:16:44 satrec12 kernel: saa7146: found saa7146 @ mem 
> > > e08e4000 (revision 1, irq 22) (0x13c2,0x100f).
> > > Apr 28 13:16:44 satrec12 kernel: DVB: registering new adapter 
> > > (TT-Budget/WinTV-NOVA-CI PCI).
> > > Apr 28 13:16:44 satrec12 kernel: adapter has MAC addr = 
> > > 00:d0:5c:24:4c:f0
> > > Apr 28 13:16:44 satrec12 kernel: budget_ci: CI interface initialised
> > > Apr 28 13:16:45 satrec12 kernel: DVB: registering frontend 1 (ST 
> > > STV0299 DVB-S)...
> > > Apr 28 13:16:45 satrec12 kernel: saa7146: found saa7146 @ mem 
> > > e0ba8000 (revision 1, irq 16) (0x13c2,0x100f).
> > > Apr 28 13:16:45 satrec12 kernel: DVB: registering new adapter 
> > > (TT-Budget/WinTV-NOVA-CI PCI).
> > > Apr 28 13:16:45 satrec12 kernel: adapter has MAC addr = 
> > > 00:d0:5c:23:b3:bd
> > > Apr 28 13:16:45 satrec12 kernel: budget_ci: CI interface initialised
> > > Apr 28 13:16:45 satrec12 kernel: DVB: registering frontend 2 (ST 
> > > STV0299 DVB-S)...
> > > Apr 28 13:16:47 satrec12 kernel: dvb_ca adapter 0: DVB CAM detected 
> > > and initialised successfully
> > > Apr 28 13:16:48 satrec12 kernel: dvb_ca adapter 1: DVB CAM detected 
> > > and initialised successfully
> > > Apr 28 13:16:48 satrec12 kernel: dvb_ca adapter 2: DVB CAM detected 
> > > and initialised successfully
> > >
> > > 3:00.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
> > >         Subsystem: Technotrend Systemtechnik GmbH: Unknown device 100f
> > >         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> > > ParErr- Stepping- SERR- FastB2B-
> > >         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium 
> > > >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > >         Latency: 32 (3750ns min, 9500ns max)
> > >         Interrupt: pin A routed to IRQ 18
> > >         Region 0: Memory at fb044000 (32-bit, non-prefetchable) 
> > > [size=512]
> > >
> > > 03:01.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
> > >         Subsystem: Technotrend Systemtechnik GmbH: Unknown device 1017
> > >         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> > > ParErr- Stepping- SERR- FastB2B-
> > >         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium 
> > > >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > >         Latency: 32 (3750ns min, 9500ns max)
> > >         Interrupt: pin A routed to IRQ 21
> > >         Region 0: Memory at fb045000 (32-bit, non-prefetchable) 
> > > [size=512]
> > >
> > > 03:02.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
> > >         Subsystem: Technotrend Systemtechnik GmbH: Unknown device 100f
> > >         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> > > ParErr- Stepping- SERR- FastB2B-
> > >         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium 
> > > >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > >         Latency: 32 (3750ns min, 9500ns max)
> > >         Interrupt: pin A routed to IRQ 22
> > >         Region 0: Memory at fb046000 (32-bit, non-prefetchable) 
> > > [size=512]
> > >
> > > 03:03.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
> > >         Subsystem: Technotrend Systemtechnik GmbH: Unknown device 100f
> > >         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> > > ParErr- Stepping- SERR- FastB2B-
> > >         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium 
> > > >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> > >         Latency: 32 (3750ns min, 9500ns max)
> > >         Interrupt: pin A routed to IRQ 16
> > >         Region 0: Memory at fb048000 (32-bit, non-prefetchable) 
> > > [size=512]
> >
> >
> > ------------------------------------------------------------------------
> >
> > _______________________________________________
> >
> > linux-dvb@xxxxxxxxxxx
> > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb


_______________________________________________

linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb