Andrew de Quincey wrote:
On Tuesday 18 April 2006 17:40, Thomas Kaiser wrote:
Hello
Technotrend Connect USB C1200
http://www.dvbshop.net/product_info.php/info/p23_Technotrend-Connect-USB-C1
200.html
I attached the files I had to change to make ttusb C-1200 (0xb48, 0x1004
) with frontend TD1316A/stv0297 work.
ttusb-budget/dvb-ttusb-budget.c
ttusb-budget/dvb-ttusb-dspbootcode.h
frontends/stv0297.c
frontends/stv0297.c:
I had to change the stv0297_readreg function, but I don't know if this
change breaks the PCI driver.
ttusb-budget/dvb-ttusb-dspbootcode.h:
From the usbsnoop on windoz, the dsp bootcode is a bit different. I
used the original dsp bootcode and it works for me. I extracted the dsp
boot code from the windoz snoop and this one is working too. So, I don't
know the differences between this two different versions. (I had to
change ttusb_boot_dsp a bit to load the new boot code)
ttusb-budget/dvb-ttusb-budget.c:
- added u8 tuner_pll_address to the ttusb struct
- changed ttusb_boot_dsp a bit
- included (with modifications) dvbc_philips_tdm1316l_pll_set,
dvbc_philips_tdm1316l_inittab, dvbc_philips_tdm1316l_config from the PCI
driver
Can anybody review my changes and include it to the official tree if it
is OK?
I hope it can help anybody to get his ttusb C-1200 device working in Linux.
Hi, the changes look good to me. I don't think I can include the new bootcode
since I have no idea what effect it would have on older devices. Since you
say the older code works as well for you, I'd be tempted to just leave that
as it is. Unless someone else knows the difference?
I'll need your signed-off-by line to include it into the tree though.
Thanks!
Hello Andrew
I just included the new boot code for completeness. It's ok for me to
use the "old" boot code.
Signed-off-by: Thomas Kaiser <linux-dvb AT kaiser-linux.li>
Regards, Thomas
--
http://www.kaiser-linux.li
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
