Greetings. Have had some very recent problems with a dvb-t card and decrypting, and thought to share it and see if anyone has any ideas where to go from here? Using a Twinhand Ter-CI dvb-t card with a CI module for viaccess. With this setup and standard 2.6.15.1 kernel and 0.8.4 version of vlc, I was not able to get descrambling working for that setup. Updating drivers from development dvb&v4l and installing that, + installing cvs version of vlc, I was finally able to decode a channel and stream it out with vlc and all was peachy. However, after that one channel was first received, I tried to switch channel, and nothing worked. Figuring card or driver might be stuck, I rebooted. and now I cannot get /dev/dvb/adapter0/frontend0 to show up again.It seems to be that the DST driver is not able to find any matching device and gives up. Had two cards however, so using that for now and only using unscrambled channels. Very reluctant to try descrambling with this until I know I wont fry this card as well however. Hopefull that someone know any way of getting this to work without disabling card#2. Thanx in advance /Roger result regarding loading these from dmesg (first the correct loading, and then the error after descrambling once): -------------------------------------------------- Linux video capture interface: v1.00 bttv: driver version 0.9.16 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI Interrupt 0000:01:06.0[A] -> GSI 18 (level, low) -> IRQ 169 bttv0: Bt878 (rev 17) at 0000:01:06.0, irq: 169, latency: 64, mmio: 0xfa001000 bttv0: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is 1822:0001 bttv0: using: Twinhan DST + clones [card=113,insmod option] bttv0: gpio: en=00000000, out=00000000 in=00f731ff [init] bttv0: using tuner=4 bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). ACPI: PCI Interrupt 0000:01:06.1[A] -> GSI 18 (level, low) -> IRQ 169 bt878(0): Bt878 (rev 17) at 01:06.1, irq: 169, latency: 64, memory: 0xfa000000 DVB: registering new adapter (bttv0). dst_get_device_id: Recognise [DTTDIG] DST type flags : 0x10 firmware version = 2 dst_get_mac: MAC Address=[00:08:ca:13:20:00] DVB: registering frontend 0 (DST DVB-T)... --------------------------------------------------- Feb 3 17:48:58 arvsele kernel: DVB: registering new adapter (bttv0). Feb 3 17:48:58 arvsele kernel: frontend_init: Could not find a Twinhan DST. Feb 3 17:48:58 arvsele kernel: dvb-bt8xx: A frontend driver was not found for device 109e/0878 subsystem 1822/0001
