Hello. I recently purchased a Twinhan VP1020A card (DVB-S), and it is listed as supported in the linuxtv site. However, I have not succeeded in making it work. I saw some posts on this list very similar to what I am experiencing, but unfortunately I did not understood the proposed solutions. I will summarize what I know: ---- dmesg reports: -------- bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:02:02.0[A] -> GSI 17 (level, low) -> IRQ 185 bttv0: Bt878 (rev 17) at 0000:02:02.0, irq: 185, latency: 32, mmio: 0xf47fe000 bttv0: detected: Twinhan VisionPlus DVB-T [card=113], PCI subsystem ID is 1822:0 001 bttv0: using: Twinhan DST + clones [card=113,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f5ffff [init] bttv0: using tuner=4 bttv0: add subdevice "dvb0" --------------------------------------- but I cannot find any device dvb0 under /dev. Following the instructions at http://www.tldp.org/HOWTO/BTTV.html, I created a /dev/video0 device, but xawtv wont work with it (v4l: open /dev/video0: No such device). On this list it is explained that's because it is a 'budget' card without a decoder. One of the replies suggested the use of mplayer to test it, but I could not find a way to do it (mplayer dvb:// reports 'DVB CONFIGURATION IS EMPTY, exit'). Questions are, 1) how do I use it / test it? and 2) has anyone used it with, for instance, MythTV? Regards, Luis Zarrabeitia.
