Hi all, I don't know I write to the right ML, coz my problems are about the driver for SAA7134-DVB (for the Pinnacle 300i) which is maintened by Gerd, but Gerd seems to be orphaned from the V4L/V4L2. I cannot tune any signal with latest sources video4linux-20050701-082418.tar.gz Kernel output is Linux video capture interface: v1.00 saa7130/34: v4l2 driver version 0.2.13 loaded saa7130/34: snapshot date 2005-07-01 ACPI: PCI interrupt 0000:02:04.0[A] -> GSI 18 (level, low) -> IRQ 185 saa7134[0]: found at 0000:02:04.0, rev: 1, irq: 185, latency: 32, mmio: 0xfe000800 saa7134[0]: subsystem: 11bd:002d, board: Pinnacle PCTV 300i DVB-T + PAL [card=50,autodetected] saa7134[0]: board init: gpio is 8806000 saa7134[0]: i2c eeprom 00: bd 11 2d 00 f8 f8 1c 00 43 43 a9 1c 55 d2 b2 92 saa7134[0]: i2c eeprom 10: 00 f0 04 04 ff 20 ff ff ff ff ff ff ff ff ff ff saa7134[0]: i2c eeprom 20: 01 40 01 02 03 ff 03 01 08 ff 00 25 ff ff ff ff saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff tuner 1-0060: chip found @ 0xc0 (saa7134[0]) tuner 1-0060: TEA5767 detected. tda9885/6/7: chip found @ 0x86 tuner 1-0060: microtune: companycode=3cbf part=42 rev=c0 tuner 1-0060: microtune MT2050 found, OK saa7134[0]: registered device video0 [v4l2] saa7134[0]: registered device vbi0 saa7134[0]: pinnacle 300i dvb setup DVB: registering new adapter (saa7134[0]). DVB: registering frontend 0 (Zarlink MT352 DVB-T)... I think I have no TEA5767 chip on card... Any ideas? -- Ondrej Zima <amiandrew@xxxxxxxx> --==[ http://www.fozona.cz/ ]==-- Prosek.CZFree.NET administrator
