On Thu, 17 Mar 2005, [iso-8859-15] Fran?ois-Xavier Payet wrote: > Thanks for your quick answer. I'm using a 2.6.11 kernel with video4linux, and > when I do a 'modprobe saa7134 "card=50"' , my dmesg gives me this : Hi Francois, the original saa7134 files in the 2.6.11 kernel lack the additional code and information found in the additional video4linux code from bytesex.org ! Are you sure, your card is a 200i ? Your lspci output looks very much like mine. > saa7130/34: v4l2 driver version 0.2.12 loaded > ACPI: PCI interrupt 0000:01:09.0[A] -> GSI 7 (level, low) -> IRQ 7 > saa7134[0]: found at 0000:01:09.0, rev: 1, irq: 7, latency: 32, mmio: > 0xde001000 > saa7134[0]: subsystem: 11bd:002d, board: Pinnacle PCTV Stereo (saa7134) > [card=26,autodetected] > saa7134[0]: board init: gpio is cc06000 > tuner: chip found at addr 0xc0 i2c-bus saa7134[0] > tuner: type set to 33 (MT20xx universal) by saa7134[0] > tuner: microtune: companycode=3cbf part=42 rev=05 > tuner: microtune MT2050 found, OK > tda9885/6/7: chip found @ 0x86 > saa7134[0]: i2c eeprom 00: bd 11 2d 00 f8 f8 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7134[0]: i2c eeprom 10: 00 f0 04 04 ff 20 ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 20: 01 40 01 02 03 ff 03 01 08 ff 00 25 ff ff ff ff > saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: registered device video0 [v4l2] > saa7134[0]: registered device vbi0 This looks exactly like what I saw on my system before I compiled the additional video4linux code from bytesex.org ! > So, there's some things I don't understand : > - Why isn't the module loaded with the card 50 as asked, but with a PCTV > Stereo card Because the code and data in the original 2.6.11 kernel code lack the additional information found in the video4linux code from bytesex.org ! Take a look at the file saa7134_cards.c to see what I mean. There are less than 50 cards defined so the "card=50" parameter is useless unless you have the additional video4linux code compiled and installed ! With card=26 you may view analogue TV but no digital TV. > - Why isn't the numeric tuner found Because the card is not defined in the kernel code saa7134_cards.c ! > > Thanks > > FX >> What you need is at least a 2.6.10 kernel and the "video4linux" sources >> from http://dl.bytesex.org/cvs-snapshots/ What you have done is mistake the kernel's video4linux code with the one from bytesex.org, you need both to make your card work ! Regards, Rainer -- Rainer Schubert - Linux TV User
