I don't know much about this but I have seen this in a dvb demodulator output and ASI convertors. These lines were termed DVALID and these used to stay high whenever there is valid data in the transport stream bus-8bit/serial. This line stays low when there are some special characters coming in the bus. I think this flag is related to that. Even error line also is similar - ie whenever there were some uncorrectable errors this is supposed to stay low - depends on your configuration Hari -----Original Message----- From: linux-dvb-bounces@xxxxxxxxxxx [mailto:linux-dvb-bounces@xxxxxxxxxxx] On Behalf Of Manu Abraham Sent: Wednesday, February 16, 2005 12:27 AM To: linux-dvb Subject: [linux-dvb] [RFC] Hi, Is there any advantage in getting the following flags out from the tuner (STV0299 based).. such that it might be of some help.. ? (1) data valid (2) error Manu _______________________________________________ linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb ************************************************************************** This email (including any attachments) is intended for the sole use of the intended recipient/s and may contain material that is CONFIDENTIAL AND PRIVATE COMPANY INFORMATION. Any review or reliance by others or copying or distribution or forwarding of any or all of the contents in this message is STRICTLY PROHIBITED. If you are not the intended recipient, please contact the sender by email and delete all copies; your cooperation in this regard is appreciated. **************************************************************************
