The condition line in if-statement is needed to be shorthen to
improve readability.
Signed-off-by: Daeseok Youn <daeseok.youn@xxxxxxxxx>
---
drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c b/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
index 94bc793..eebfccd 100644
--- a/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
+++ b/drivers/staging/media/atomisp/pci/atomisp2/atomisp_cmd.c
@@ -255,14 +255,17 @@ int atomisp_freq_scaling(struct atomisp_device *isp,
struct atomisp_freq_scaling_rule curr_rules;
int i, ret;
unsigned short fps = 0;
+ unsigned short masked_dev = 0;
if (isp->sw_contex.power_state != ATOM_ISP_POWER_UP) {
dev_err(isp->dev, "DFS cannot proceed due to no power.\n");
return -EINVAL;
}
- if ((isp->pdev->device & ATOMISP_PCI_DEVICE_SOC_MASK) ==
- ATOMISP_PCI_DEVICE_SOC_CHT && ATOMISP_USE_YUVPP(asd))
+ masked_dev = isp->pdev->device & ATOMISP_PCI_DEVICE_SOC_MASK;
+
+ if (masked_dev == ATOMISP_PCI_DEVICE_SOC_CHT &&
+ ATOMISP_USE_YUVPP(asd))
isp->dfs = &dfs_config_cht_soc;
if (isp->dfs->lowest_freq == 0 || isp->dfs->max_freq_at_vmin == 0 ||
--
1.9.1
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
