Re: [RFC PATCH v2 06/32] x86/pci: Use memremap when walking setup data

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 3/3/2017 2:42 PM, Bjorn Helgaas wrote:
On Thu, Mar 02, 2017 at 10:13:10AM -0500, Brijesh Singh wrote:
From: Tom Lendacky <thomas.lendacky@xxxxxxx>

The use of ioremap will force the setup data to be mapped decrypted even
though setup data is encrypted.  Switch to using memremap which will be
able to perform the proper mapping.

How should callers decide whether to use ioremap() or memremap()?

memremap() existed before SME and SEV, and this code is used even if
SME and SEV aren't supported, so the rationale for this change should
not need the decryption argument.

When SME or SEV is active an ioremap() will remove the encryption bit
from the pagetable entry when it is mapped.  This allows MMIO, which
doesn't support SME/SEV, to be performed successfully.  So my take is
that ioremap() should be used for MMIO and memremap() for pages in RAM.


Signed-off-by: Tom Lendacky <thomas.lendacky@xxxxxxx>
---
 arch/x86/pci/common.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/x86/pci/common.c b/arch/x86/pci/common.c
index a4fdfa7..0b06670 100644
--- a/arch/x86/pci/common.c
+++ b/arch/x86/pci/common.c
@@ -691,7 +691,7 @@ int pcibios_add_device(struct pci_dev *dev)

 	pa_data = boot_params.hdr.setup_data;
 	while (pa_data) {
-		data = ioremap(pa_data, sizeof(*rom));
+		data = memremap(pa_data, sizeof(*rom), MEMREMAP_WB);

I can't quite connect the dots here.  ioremap() on x86 would do
ioremap_nocache().  memremap(MEMREMAP_WB) would do arch_memremap_wb(),
which is ioremap_cache().  Is making a cacheable mapping the important
difference?

The memremap(MEMREMAP_WB) will actually check to see if it can perform
a __va(pa_data) in try_ram_remap() and then fallback to the
arch_memremap_wb().  So it's actually the __va() vs the ioremap_cache()
that is the difference.

Thanks,
Tom


 		if (!data)
 			return -ENOMEM;

@@ -710,7 +710,7 @@ int pcibios_add_device(struct pci_dev *dev)
 			}
 		}
 		pa_data = data->next;
-		iounmap(data);
+		memunmap(data);
 	}
 	set_dma_domain_ops(dev);
 	set_dev_domain_options(dev);

_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux