On 03/03/2017 03:45 AM, Sakari Ailus wrote:
On Thu, Mar 02, 2017 at 03:07:21PM -0800, Steve Longerbeam wrote:
On 03/02/2017 07:53 AM, Sakari Ailus wrote:
Hi Steve,
On Wed, Feb 15, 2017 at 06:19:15PM -0800, Steve Longerbeam wrote:
Add a new FRAME_TIMEOUT event to signal that a video capture or
output device has timed out waiting for reception or transmit
completion of a video frame.
Signed-off-by: Steve Longerbeam <steve_longerbeam@xxxxxxxxxx>
---
Documentation/media/uapi/v4l/vidioc-dqevent.rst | 5 +++++
Documentation/media/videodev2.h.rst.exceptions | 1 +
include/uapi/linux/videodev2.h | 1 +
3 files changed, 7 insertions(+)
diff --git a/Documentation/media/uapi/v4l/vidioc-dqevent.rst b/Documentation/media/uapi/v4l/vidioc-dqevent.rst
index 8d663a7..dd77d9b 100644
--- a/Documentation/media/uapi/v4l/vidioc-dqevent.rst
+++ b/Documentation/media/uapi/v4l/vidioc-dqevent.rst
@@ -197,6 +197,11 @@ call.
the regions changes. This event has a struct
:c:type:`v4l2_event_motion_det`
associated with it.
+ * - ``V4L2_EVENT_FRAME_TIMEOUT``
+ - 7
+ - This event is triggered when the video capture or output device
+ has timed out waiting for the reception or transmit completion of
+ a frame of video.
As you're adding a new interface, I suppose you have an implementation
around. How do you determine what that timeout should be?
The imx-media driver sets the timeout to 1 second, or 30 frame
periods at 30 fps.
The frame rate is not necessarily constant during streaming. It may well
change as a result of lighting conditions.
I think you mean that would be a _temporary_ change in frame rate, but
yes I agree the data rate can temporarily fluctuate. Although I doubt
lighting conditions would cause a sensor to pause data transmission
for a full 1 second.
I wouldn't add an event for this:
this is unreliable and 30 times the frame period is an arbitrary value
anyway. No other drivers do this either.
If no other drivers do this I don't mind removing it. It is really meant
to deal with the ADV718x CVBS decoder, which often simply stops sending
data on the BT.656 bus if there is an interruption in the input analog
signal. But I agree that user space could detect this timeout instead.
Unless I hear from someone else that they would like to keep this
feature I'll remove it in version 5.
Steve
The user space is generally in control of the frame period (or on some
devices it could be the sensor, too, but *not* the CSI-2 receiver driver),
so detecting the condition of not receiving any frames is more reliably done
in the user space --- if needed.
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
