ERROR: Use 4 digit octal (0777) not decimal permissions This error was detected by checkpatch.pl Signed-off-by: Nadim Almas <nadim.902@xxxxxxxxx> --- drivers/staging/fbtft/fb_ili9325.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/staging/fbtft/fb_ili9325.c b/drivers/staging/fbtft/fb_ili9325.c index 4ab4479..19e33ba 100644 --- a/drivers/staging/fbtft/fb_ili9325.c +++ b/drivers/staging/fbtft/fb_ili9325.c @@ -33,23 +33,23 @@ "04 16 2 7 6 3 2 1 7 7" static unsigned int bt = 6; /* VGL=Vci*4 , VGH=Vci*4 */ -module_param(bt, uint, 0); +module_param(bt, uint, 0000); MODULE_PARM_DESC(bt, "Sets the factor used in the step-up circuits"); static unsigned int vc = 0x03; /* Vci1=Vci*0.80 */ -module_param(vc, uint, 0); +module_param(vc, uint, 0000); MODULE_PARM_DESC(vc, "Sets the ratio factor of Vci to generate the reference voltages Vci1"); static unsigned int vrh = 0x0d; /* VREG1OUT=Vci*1.85 */ -module_param(vrh, uint, 0); +module_param(vrh, uint, 0000); MODULE_PARM_DESC(vrh, "Set the amplifying rate (1.6 ~ 1.9) of Vci applied to output the VREG1OUT"); static unsigned int vdv = 0x12; /* VCOMH amplitude=VREG1OUT*0.98 */ -module_param(vdv, uint, 0); +module_param(vdv, uint, 0000); MODULE_PARM_DESC(vdv, "Select the factor of VREG1OUT to set the amplitude of Vcom"); static unsigned int vcm = 0x0a; /* VCOMH=VREG1OUT*0.735 */ -module_param(vcm, uint, 0); +module_param(vcm, uint, 0000); MODULE_PARM_DESC(vcm, "Set the internal VcomH voltage"); /* -- 2.7.4 _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
