Block comments should align the * on each line as reported by checkpatch
Signed-off-by: Jakub Jedelsky <jakub.jedelsky@xxxxxxxxx>
---
drivers/staging/comedi/drivers/cb_pcidda.c | 4 ++--
drivers/staging/comedi/drivers/mite.c | 2 +-
drivers/staging/comedi/drivers/pcl818.c | 6 +++---
3 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/drivers/staging/comedi/drivers/cb_pcidda.c b/drivers/staging/comedi/drivers/cb_pcidda.c
index ccb37d1..9874147 100644
--- a/drivers/staging/comedi/drivers/cb_pcidda.c
+++ b/drivers/staging/comedi/drivers/cb_pcidda.c
@@ -248,8 +248,8 @@ static void cb_pcidda_write_caldac(struct comedi_device *dev,
cb_pcidda_serial_out(dev, value, num_caldac_bits);
/*
-* latch stream into appropriate caldac deselect reference dac
-*/
+ * latch stream into appropriate caldac deselect reference dac
+ */
cal2_bits = DESELECT_REF_DAC_BIT | DUMMY_BIT;
/* deactivate caldacs (one caldac for every two channels) */
for (i = 0; i < max_num_caldacs; i++)
diff --git a/drivers/staging/comedi/drivers/mite.c b/drivers/staging/comedi/drivers/mite.c
index b1c0860..05126ba 100644
--- a/drivers/staging/comedi/drivers/mite.c
+++ b/drivers/staging/comedi/drivers/mite.c
@@ -837,7 +837,7 @@ static int mite_setup(struct comedi_device *dev, struct mite *mite,
* of 0x61f and bursts worked. 6281 powered up with register value of
* 0x1f and bursts didn't work. The NI windows driver reads the
* register, then does a bitwise-or of 0x600 with it and writes it back.
- *
+ *
* The bits 0x90180700 in MITE_UNKNOWN_DMA_BURST_REG can be
* written and read back. The bits 0x1f always read as 1.
* The rest always read as zero.
diff --git a/drivers/staging/comedi/drivers/pcl818.c b/drivers/staging/comedi/drivers/pcl818.c
index 5aeed44..5b5df05 100644
--- a/drivers/staging/comedi/drivers/pcl818.c
+++ b/drivers/staging/comedi/drivers/pcl818.c
@@ -771,9 +771,9 @@ static int pcl818_ai_cancel(struct comedi_device *dev,
s->async->scans_done < cmd->stop_arg)) {
if (!devpriv->ai_cmd_canceled) {
/*
- * Wait for running dma transfer to end,
- * do cleanup in interrupt.
- */
+ * Wait for running dma transfer to end,
+ * do cleanup in interrupt.
+ */
devpriv->ai_cmd_canceled = 1;
return 0;
}
--
2.5.5
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
