This patch fixes the following checkpatch.pl warning in rtsx_chip.h:
WARNING: Block comments use a trailing */ on a separate line
Signed-off-by: Sergio Paracuellos <sergio.paracuellos@xxxxxxxxx>
---
drivers/staging/rts5208/rtsx_chip.h | 52 +++++++++++++++++++------------------
1 file changed, 27 insertions(+), 25 deletions(-)
diff --git a/drivers/staging/rts5208/rtsx_chip.h b/drivers/staging/rts5208/rtsx_chip.h
index 6ef34fa..f366428 100644
--- a/drivers/staging/rts5208/rtsx_chip.h
+++ b/drivers/staging/rts5208/rtsx_chip.h
@@ -44,8 +44,10 @@
#define MG_SET_ICV_SLOW
/* HW may miss ERR/CMDNK signal when sampling INT status. */
#define MS_SAMPLE_INT_ERR
- /* HW DO NOT support Wait_INT function during READ_BYTES
- * transfer mode */
+ /*
+ * HW DO NOT support Wait_INT function
+ * during READ_BYTES transfer mode
+ */
#define READ_BYTES_WAIT_INT
#endif
@@ -101,17 +103,17 @@
#define TRANSPORT_NO_SENSE 2 /* Command failed, no auto-sense */
#define TRANSPORT_ERROR 3 /* Transport bad (i.e. device dead) */
-/*-----------------------------------
- Start-Stop-Unit
------------------------------------*/
+/*
+ * Start-Stop-Unit
+ */
#define STOP_MEDIUM 0x00 /* access disable */
#define MAKE_MEDIUM_READY 0x01 /* access enable */
#define UNLOAD_MEDIUM 0x02 /* unload */
#define LOAD_MEDIUM 0x03 /* load */
-/*-----------------------------------
- STANDARD_INQUIRY
------------------------------------*/
+/*
+ * STANDARD_INQUIRY
+ */
#define QULIFIRE 0x00
#define AENC_FNC 0x00
#define TRML_IOP 0x00
@@ -128,17 +130,15 @@
#define PRDCT_REV_LEN 4 /* Product LOT Length */
/* Dynamic flag definitions: used in set_bit() etc. */
-#define RTSX_FLIDX_TRANS_ACTIVE 18 /* 0x00040000 transfer is active */
-#define RTSX_FLIDX_ABORTING 20 /* 0x00100000 abort is in
- * progress */
-#define RTSX_FLIDX_DISCONNECTING 21 /* 0x00200000 disconnect
- * in progress */
+#define RTSX_FLIDX_TRANS_ACTIVE 18 /* 0x00040000 transfer is active */
+#define RTSX_FLIDX_ABORTING 20 /* 0x00100000 abort is in progress */
+#define RTSX_FLIDX_DISCONNECTING 21 /* 0x00200000 disconnect in progress */
+
#define ABORTING_OR_DISCONNECTING ((1UL << US_FLIDX_ABORTING) | \
(1UL << US_FLIDX_DISCONNECTING))
-#define RTSX_FLIDX_RESETTING 22 /* 0x00400000 device reset
- * in progress */
-#define RTSX_FLIDX_TIMED_OUT 23 /* 0x00800000 SCSI
- * midlayer timed out */
+
+#define RTSX_FLIDX_RESETTING 22 /* 0x00400000 device reset in progress */
+#define RTSX_FLIDX_TIMED_OUT 23 /* 0x00800000 SCSI midlayer timed out */
#define DRCT_ACCESS_DEV 0x00 /* Direct Access Device */
#define RMB_DISC 0x80 /* The Device is Removable */
@@ -173,9 +173,9 @@
#define FIRST_RESET 0x01
#define USED_EXIST 0x02
-/*-----------------------------------
- SENSE_DATA
------------------------------------*/
+/*
+ * SENSE_DATA
+ */
/*---- valid ----*/
#define SENSE_VALID 0x80 /* Sense data is valid as SCSI2 */
#define SENSE_INVALID 0x00 /* Sense data is invalid as SCSI2 */
@@ -706,9 +706,9 @@ struct rtsx_chip {
int cur_card;
unsigned long need_release; /* need release bit map */
- unsigned long need_reset; /* need reset
- * bit map */
- /* Flag to indicate that this card is just resumed from SS state,
+ unsigned long need_reset; /* need reset bit map */
+ /*
+ * Flag to indicate that this card is just resumed from SS state,
* and need released before being resetted
*/
unsigned long need_reinit;
@@ -726,8 +726,10 @@ struct rtsx_chip {
u8 card_ejected; /* card ejected bit map */
u8 card_wp; /* card write protected bit map */
- u8 lun_mc; /* flag to indicate whether to answer
- * MediaChange */
+ u8 lun_mc; /*
+ * flag to indicate whether to answer
+ * MediaChange
+ */
#ifndef LED_AUTO_BLINK
int led_toggle_counter;
--
1.9.1
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
