[PATCH v2 16/43] staging: comedi: ni_660x: fix block comment issues

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Fix the checkpatch.pl issues about:

WARNING: Block comments use * on subsequent lines
WARNING: Block comments use a trailing */ on a separate line

Signed-off-by: H Hartley Sweeten <hsweeten@xxxxxxxxxxxxxxxxxxx>
Cc: Ian Abbott <abbotti@xxxxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
 drivers/staging/comedi/drivers/ni_660x.c | 17 +++++++++++------
 1 file changed, 11 insertions(+), 6 deletions(-)

diff --git a/drivers/staging/comedi/drivers/ni_660x.c b/drivers/staging/comedi/drivers/ni_660x.c
index 232c897..0183497 100644
--- a/drivers/staging/comedi/drivers/ni_660x.c
+++ b/drivers/staging/comedi/drivers/ni_660x.c
@@ -48,8 +48,7 @@ enum ni_660x_constants {
 };
 
 #define NUM_PFI_CHANNELS 40
-/* really there are only up to 3 dma channels, but the register layout allows
-for 4 */
+/* there are only up to 3 dma channels, but the register layout allows for 4 */
 #define MAX_DMA_CHANNEL 4
 
 /* See Register-Level Programmer Manual page 3.1 */
@@ -985,8 +984,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev,
 	s->range_table = &range_digital;
 	s->insn_bits = ni_660x_dio_insn_bits;
 	s->insn_config = ni_660x_dio_insn_config;
-	/*  we use the ioconfig registers to control dio direction, so zero
-	output enables in stc dio control reg */
+
+	/*
+	 * We use the ioconfig registers to control dio direction, so zero
+	 * output enables in stc dio control reg.
+	 */
 	ni_660x_write(dev, 0, 0, NI660X_STC_DIO_CONTROL);
 
 	devpriv->counter_dev = ni_gpct_device_construct(dev,
@@ -1040,8 +1042,11 @@ static int ni_660x_auto_attach(struct comedi_device *dev,
 						NI660X_IO_CFG_OUT_SEL_COUNTER);
 		ni_660x_select_pfi_output(dev, i, NI660X_IO_CFG_OUT_SEL_HIGH_Z);
 	}
-	/* to be safe, set counterswap bits on tio chips after all the counter
-	   outputs have been set to high impedance mode */
+
+	/*
+	 * To be safe, set counterswap bits on tio chips after all the counter
+	 * outputs have been set to high impedance mode.
+	 */
 	for (i = 0; i < board->n_chips; ++i)
 		set_tio_counterswap(dev, i);
 
-- 
2.6.3

_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux