On Monday 19 October 2015 11:53:40 Arnd Bergmann wrote: > On Monday 19 October 2015 11:39:31 Arnd Bergmann wrote: > > On Monday 19 October 2015 16:54:23 Tony Cho wrote: > > > Hi Arnd Bergmann, > > > > > > When I apply this patch, I cannot make WILC1000 module (wilc1000.ko) because CONFIG_WILC1000 is y and also I can see some link errors for the cfg80211 APIs. > > > > > > Can you consider this patch? > > > > Ah, you are right. I see the same thing now and don't know what caused me > > to send the patch in an incomplete state. > > > > I hope this snippet is the last missing piece: > > > > No, that was not it either, I'll start over to think this through. > > The real solution of course is to make it possible to load both the > SPI and MMC front-ends at the same time and have a common base driver, > which I might have to do, in order to clear myself of the shame of sending > not one but two incorrect fixes for this problem I spent too much time on it now, but I have a series that should fix this part for real and let you build both drivers into the kernel (or as modules) in a single configuration. Arnd _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
