Calling the setup of the SPI master directly causes a NULL pointer
dereference with master drivers without a separate setup function.
This problem is reproduceable on ARM MXS platform.
So fix this issue by using spi_setup() instead.
Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx>
---
drivers/staging/fbtft/fb_uc1611.c | 2 +-
drivers/staging/fbtft/fb_watterott.c | 4 ++--
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/staging/fbtft/fb_uc1611.c b/drivers/staging/fbtft/fb_uc1611.c
index 32f3a9d..5cafa50 100644
--- a/drivers/staging/fbtft/fb_uc1611.c
+++ b/drivers/staging/fbtft/fb_uc1611.c
@@ -76,7 +76,7 @@ static int init_display(struct fbtft_par *par)
/* Set CS active high */
par->spi->mode |= SPI_CS_HIGH;
- ret = par->spi->master->setup(par->spi);
+ ret = spi_setup(par->spi);
if (ret) {
dev_err(par->info->device, "Could not set SPI_CS_HIGH\n");
return ret;
diff --git a/drivers/staging/fbtft/fb_watterott.c b/drivers/staging/fbtft/fb_watterott.c
index 88fb2c0..8eae6ef 100644
--- a/drivers/staging/fbtft/fb_watterott.c
+++ b/drivers/staging/fbtft/fb_watterott.c
@@ -169,7 +169,7 @@ static int init_display(struct fbtft_par *par)
/* enable SPI interface by having CS and MOSI low during reset */
save_mode = par->spi->mode;
par->spi->mode |= SPI_CS_HIGH;
- ret = par->spi->master->setup(par->spi); /* set CS inactive low */
+ ret = spi_setup(par->spi); /* set CS inactive low */
if (ret) {
dev_err(par->info->device, "Could not set SPI_CS_HIGH\n");
return ret;
@@ -180,7 +180,7 @@ static int init_display(struct fbtft_par *par)
par->fbtftops.reset(par);
mdelay(1000);
par->spi->mode = save_mode;
- ret = par->spi->master->setup(par->spi);
+ ret = spi_setup(par->spi);
if (ret) {
dev_err(par->info->device, "Could not restore SPI mode\n");
return ret;
--
1.7.9.5
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
