[PATCH 01/14] MIPS: OCTEON: fix CN6880 hang on XAUI init

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Janne Huttunen <janne.huttunen@xxxxxxxxx>

Some CN68XX series Octeon II chips seem to hang if a reset is issued on
XAUI initialization. Avoid the hang by disabling the reset on affected
models. Tested on Cavium EBB6800 evaluation board and Kontron S1901 board.

Signed-off-by: Janne Huttunen <janne.huttunen@xxxxxxxxx>
Signed-off-by: Aaro Koskinen <aaro.koskinen@xxxxxxxxx>
---
 arch/mips/cavium-octeon/executive/cvmx-helper-xaui.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/arch/mips/cavium-octeon/executive/cvmx-helper-xaui.c b/arch/mips/cavium-octeon/executive/cvmx-helper-xaui.c
index 7653b7e..323a784 100644
--- a/arch/mips/cavium-octeon/executive/cvmx-helper-xaui.c
+++ b/arch/mips/cavium-octeon/executive/cvmx-helper-xaui.c
@@ -151,7 +151,12 @@ int __cvmx_helper_xaui_enable(int interface)
 	/* (4)c Aply reset sequence */
 	xauiCtl.u64 = cvmx_read_csr(CVMX_PCSXX_CONTROL1_REG(interface));
 	xauiCtl.s.lo_pwr = 0;
-	xauiCtl.s.reset = 1;
+
+	/* Issuing a reset here seems to hang some CN68XX chips. */
+	if (!OCTEON_IS_MODEL(OCTEON_CN68XX_PASS1_X) &&
+	    !OCTEON_IS_MODEL(OCTEON_CN68XX_PASS2_X))
+		xauiCtl.s.reset = 1;
+
 	cvmx_write_csr(CVMX_PCSXX_CONTROL1_REG(interface), xauiCtl.u64);
 
 	/* Wait for PCS to come out of reset */
-- 
2.4.3

_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux