Re: [PATCH v3 20/20] arm: mach-pxa: Decrement the power supply's device reference counter

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On pią, 2015-02-06 at 14:49 +0100, Pavel Machek wrote:
> On Fri 2015-01-30 15:47:58, Krzysztof Kozlowski wrote:
> > Use power_supply_put() to decrement the power supply's device reference
> > counter.
> > 
> > Signed-off-by: Krzysztof Kozlowski <k.kozlowski@xxxxxxxxxxx>
> > Reviewed-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
> > Reviewed-by: Sebastian Reichel <sre@xxxxxxxxxx>
> 
> 11,13,20 nothing obviously wrong. But I'm not sure if I studied them
> closely enough to warrant an ACK.
> 
> It would be good to get this into kernel -- I seen no bad comments,
> and it is not going to improve without merge into mainline.

Thanks for looking at patchset. It would be really nice if this could be
tested for some time in linux-next. Such testing would help a lot. But I
need acks from various maintainers for that.

Of course the patchset to big enough to go into 3.20. If needed this
could be taken gradually in following steps:
1. Patches 1-2 (patch 2 touches *all drivers*),
2. Patches 3-10 (touch only individual drivers),
3. Patch 11 (again *everything* changed),
4. Patches 12-20 (individual changes).

In such case I will refresh everything after each step so new drivers
would be also updated.

Thanks again Pavel for prompt replies.

Best regards,
Krzysztof

_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel





[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux