The if and the else branch code are identical - so the condition has no
effect on the effective code - this patch removes the condition and the
duplicated code.
Signed-off-by: Nicholas Mc Guire <hofrat@xxxxxxxxx>
---
The if/else performing the same settings in both branches so the
condition has no effect.
This needs a check by someone who knows the details of the driver
as it could be that the two branches actually should be different.
Patch was only compile-tested for x86_64_defconfig + CONFIG_STAGING=y
CONFIG_R8188EU=m
Patch is against 3.19.0-rc7 (localversion-next is -next-20150204)
drivers/staging/rtl8188eu/hal/odm.c | 9 ++-------
1 file changed, 2 insertions(+), 7 deletions(-)
diff --git a/drivers/staging/rtl8188eu/hal/odm.c b/drivers/staging/rtl8188eu/hal/odm.c
index 9873998..878c460 100644
--- a/drivers/staging/rtl8188eu/hal/odm.c
+++ b/drivers/staging/rtl8188eu/hal/odm.c
@@ -534,13 +534,8 @@ void odm_DIGInit(struct odm_dm_struct *pDM_Odm)
pDM_DigTable->RssiHighThresh = DM_DIG_THRESH_HIGH;
pDM_DigTable->FALowThresh = DM_false_ALARM_THRESH_LOW;
pDM_DigTable->FAHighThresh = DM_false_ALARM_THRESH_HIGH;
- if (pDM_Odm->BoardType == ODM_BOARD_HIGHPWR) {
- pDM_DigTable->rx_gain_range_max = DM_DIG_MAX_NIC;
- pDM_DigTable->rx_gain_range_min = DM_DIG_MIN_NIC;
- } else {
- pDM_DigTable->rx_gain_range_max = DM_DIG_MAX_NIC;
- pDM_DigTable->rx_gain_range_min = DM_DIG_MIN_NIC;
- }
+ pDM_DigTable->rx_gain_range_max = DM_DIG_MAX_NIC;
+ pDM_DigTable->rx_gain_range_min = DM_DIG_MIN_NIC;
pDM_DigTable->BackoffVal = DM_DIG_BACKOFF_DEFAULT;
pDM_DigTable->BackoffVal_range_max = DM_DIG_BACKOFF_MAX;
pDM_DigTable->BackoffVal_range_min = DM_DIG_BACKOFF_MIN;
--
1.7.10.4
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
