Replace use of `TRIG_WAKE_EOS` command flag with the new name `CMDF_WAKE_EOS`. The numeric value is the same. Signed-off-by: Ian Abbott <abbotti@xxxxxxxxx> --- drivers/staging/comedi/drivers/ni_labpc_common.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/staging/comedi/drivers/ni_labpc_common.c b/drivers/staging/comedi/drivers/ni_labpc_common.c index 5238a98..1881510 100644 --- a/drivers/staging/comedi/drivers/ni_labpc_common.c +++ b/drivers/staging/comedi/drivers/ni_labpc_common.c @@ -689,13 +689,13 @@ static int labpc_ai_cmd(struct comedi_device *dev, struct comedi_subdevice *s) /* figure out what method we will use to transfer data */ if (labpc_have_dma_chan(dev) && /* dma unsafe at RT priority, - * and too much setup time for TRIG_WAKE_EOS */ - (cmd->flags & (TRIG_WAKE_EOS | CMDF_PRIORITY)) == 0) + * and too much setup time for CMDF_WAKE_EOS */ + (cmd->flags & (CMDF_WAKE_EOS | CMDF_PRIORITY)) == 0) xfer = isa_dma_transfer; else if (/* pc-plus has no fifo-half full interrupt */ board->is_labpc1200 && /* wake-end-of-scan should interrupt on fifo not empty */ - (cmd->flags & TRIG_WAKE_EOS) == 0 && + (cmd->flags & CMDF_WAKE_EOS) == 0 && /* make sure we are taking more than just a few points */ (cmd->stop_src != TRIG_COUNT || devpriv->count > 256)) xfer = fifo_half_full_transfer; -- 2.1.0 _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
