In sd_sync_cache:
rq->timeout *= SD_FLUSH_TIMEOUT_MULTIPLIER;
Regardless of the baseline for the multiplication, a magic
number of 2 is too arbitrary. That might work for an
individual drive, but could be far too short for a RAID
controller that runs into worst case error handling for
the drives to which it is flushing (e.g., if its cache
is volatile and the drives all have recoverable errors
during writes). That time goes up with a bigger cache and
with more fragmented write data in the cache requiring
more individual WRITE commands.
A better value would be the Recommended Command Timeout field
value reported in the REPORT SUPPORTED OPERATION CODES command,
if reported by the device server. That is supposed to account
for the worst case.
For cases where that is not reported, exposing the multiplier
in sysfs would let the timeout for simple devices be set to
smaller values than complex devices.
Also, in both sd_setup_flush_cmnd and sd_sync_cache:
cmd->cmnd[0] = SYNCHRONIZE_CACHE;
cmd->cmd_len = 10;
SYNCHRONIZE CACHE (16) should be favored over SYNCHRONIZE
CACHE (10) unless SYNCHRONIZE CACHE (10) is not supported.
---
Rob Elliott HP Server Storage
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
