This board always has 32 digital inputs. Remove the test when
initializing the subdevice.
Also, since this board is the only one supported by this driver,
remove the boardinfo about the digital inputs and just use the
data directly in the subdevice init.
Signed-off-by: Chase Southwood <chase.southwood@xxxxxxxxx>
Cc: Ian Abbott <abbotti@xxxxxxxxx>
Cc: H Hartley Sweeten <hsweeten@xxxxxxxxxxxxxxxxxxx>
---
2: Changed incorrect title.
drivers/staging/comedi/drivers/addi_apci_1564.c | 26 +++++++++----------------
1 file changed, 9 insertions(+), 17 deletions(-)
diff --git a/drivers/staging/comedi/drivers/addi_apci_1564.c b/drivers/staging/comedi/drivers/addi_apci_1564.c
index c84e17c..fe42f9d 100644
--- a/drivers/staging/comedi/drivers/addi_apci_1564.c
+++ b/drivers/staging/comedi/drivers/addi_apci_1564.c
@@ -20,8 +20,6 @@ static const struct addi_board apci1564_boardtypes[] = {
.i_Timer = 1,
.interrupt = apci1564_interrupt,
.reset = apci1564_reset,
- .di_config = apci1564_di_config,
- .di_bits = apci1564_di_insn_bits,
.do_config = apci1564_do_config,
.do_bits = apci1564_do_insn_bits,
.do_read = apci1564_do_read,
@@ -115,21 +113,15 @@ static int apci1564_auto_attach(struct comedi_device *dev,
/* Allocate and Initialise DI Subdevice Structures */
s = &dev->subdevices[2];
- if (devpriv->s_EeParameters.i_NbrDiChannel) {
- s->type = COMEDI_SUBD_DI;
- s->subdev_flags = SDF_READABLE | SDF_GROUND | SDF_COMMON;
- s->n_chan = devpriv->s_EeParameters.i_NbrDiChannel;
- s->maxdata = 1;
- s->len_chanlist =
- devpriv->s_EeParameters.i_NbrDiChannel;
- s->range_table = &range_digital;
- s->insn_config = this_board->di_config;
- s->insn_read = this_board->di_read;
- s->insn_write = this_board->di_write;
- s->insn_bits = this_board->di_bits;
- } else {
- s->type = COMEDI_SUBD_UNUSED;
- }
+ s->type = COMEDI_SUBD_DI;
+ s->subdev_flags = SDF_READABLE;
+ s->n_chan = 32;
+ s->maxdata = 1;
+ s->len_chanlist = 32;
+ s->range_table = &range_digital;
+ s->insn_config = apci1564_di_config;
+ s->insn_bits = apci1564_di_insn_bits;
+
/* Allocate and Initialise DO Subdevice Structures */
s = &dev->subdevices[3];
if (devpriv->s_EeParameters.i_NbrDoChannel) {
--
1.9.0
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
