According to the datasheet, setting the di0_polarity_disp_clk field in the GENERAL di register sets the output clock polarity to active high. Signed-off-by: Denis Carikli <denis@xxxxxxxxxx> --- ChangeLog v8->v9: - New patch that is now needed by the "staging: imx-drm: Use de-active and pixelclk-active" patch. --- drivers/staging/imx-drm/ipu-v3/ipu-di.c | 2 +- drivers/staging/imx-drm/ipuv3-crtc.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/staging/imx-drm/ipu-v3/ipu-di.c b/drivers/staging/imx-drm/ipu-v3/ipu-di.c index 82a9eba..849b3e1 100644 --- a/drivers/staging/imx-drm/ipu-v3/ipu-di.c +++ b/drivers/staging/imx-drm/ipu-v3/ipu-di.c @@ -595,7 +595,7 @@ int ipu_di_init_sync_panel(struct ipu_di *di, struct ipu_di_signal_cfg *sig) } } - if (!sig->clk_pol) + if (sig->clk_pol) di_gen |= DI_GEN_POLARITY_DISP_CLK; ipu_di_write(di, di_gen, DI_GENERAL); diff --git a/drivers/staging/imx-drm/ipuv3-crtc.c b/drivers/staging/imx-drm/ipuv3-crtc.c index e646017..f506075 100644 --- a/drivers/staging/imx-drm/ipuv3-crtc.c +++ b/drivers/staging/imx-drm/ipuv3-crtc.c @@ -158,7 +158,7 @@ static int ipu_crtc_mode_set(struct drm_crtc *crtc, sig_cfg.Vsync_pol = 1; sig_cfg.enable_pol = 1; - sig_cfg.clk_pol = 1; + sig_cfg.clk_pol = 0; sig_cfg.width = mode->hdisplay; sig_cfg.height = mode->vdisplay; sig_cfg.pixel_fmt = out_pixel_fmt; -- 1.7.9.5 _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
