This patch fixed trailing whitespace error found by
checkpatch.pl in dgap/digi.h
Signed-off-by: Masanari Iida <standby24x7@xxxxxxxxx>
---
drivers/staging/dgap/digi.h | 24 ++++++++++++------------
1 file changed, 12 insertions(+), 12 deletions(-)
diff --git a/drivers/staging/dgap/digi.h b/drivers/staging/dgap/digi.h
index bcea4f7..fe87903 100644
--- a/drivers/staging/dgap/digi.h
+++ b/drivers/staging/dgap/digi.h
@@ -43,7 +43,7 @@
#define TIOCMODG ('d'<<8) | 250 /* get modem ctrl state */
#define TIOCMODS ('d'<<8) | 251 /* set modem ctrl state */
-#ifndef TIOCM_LE
+#ifndef TIOCM_LE
#define TIOCM_LE 0x01 /* line enable */
#define TIOCM_DTR 0x02 /* data terminal ready */
#define TIOCM_RTS 0x04 /* request to send */
@@ -122,7 +122,7 @@ struct digiflow_t {
#endif
/************************************************************************
- * Values for digi_flags
+ * Values for digi_flags
************************************************************************/
#define DIGI_IXON 0x0001 /* Handle IXON in the FEP */
#define DIGI_FAST 0x0002 /* Fast baud rates */
@@ -193,8 +193,8 @@ struct rw_t {
#define COMXI_TYPE 5 /* Board type at the designated port is a COM/Xi */
/* Non-Zero Result codes. */
-#define RESULT_NOBDFND 1 /* A Digi product at that port is not config installed */
-#define RESULT_NODESCT 2 /* A memory descriptor was not obtainable */
+#define RESULT_NOBDFND 1 /* A Digi product at that port is not config installed */
+#define RESULT_NODESCT 2 /* A memory descriptor was not obtainable */
#define RESULT_NOOSSIG 3 /* FEP/OS signature was not detected on the board */
#define RESULT_TOOSML 4 /* Too small an area to shrink. */
#define RESULT_NOCHAN 5 /* Channel structure for the board was not found */
@@ -205,7 +205,7 @@ struct shrink_buf_struct {
unsigned long shrink_buf_bseg; /* Amount of board memory */
unsigned long shrink_buf_hseg; /* '186 Beginning of Dual-Port */
- unsigned long shrink_buf_lseg; /* '186 Beginning of freed memory */
+ unsigned long shrink_buf_lseg; /* '186 Beginning of freed memory */
unsigned long shrink_buf_mseg; /* Linear address from start of
dual-port were freed memory
begins, host viewpoint. */
@@ -220,18 +220,18 @@ struct shrink_buf_struct {
unsigned char shrink_buf_result; /* Reason for call failing
Zero is Good return */
- unsigned char shrink_buf_init; /* Non-Zero if it caused an
+ unsigned char shrink_buf_init; /* Non-Zero if it caused an
xxinit call. */
unsigned char shrink_buf_anports; /* Number of async ports */
unsigned char shrink_buf_snports; /* Number of sync ports */
unsigned char shrink_buf_type; /* Board type 1 = PC/Xi,
2 = PC/Xm,
- 3 = PC/Xe
- 4 = MC/Xi
+ 3 = PC/Xe
+ 4 = MC/Xi
5 = COMX/i */
unsigned char shrink_buf_card; /* Card number */
-
+
};
/************************************************************************
@@ -244,7 +244,7 @@ struct digi_dinfo {
};
#define DIGI_GETDD ('d'<<8) | 248 /* get driver info */
-
+
/************************************************************************
* Structure used with ioctl commands for per-board information
*
@@ -264,7 +264,7 @@ struct digi_info {
};
#define DIGI_GETBD ('d'<<8) | 249 /* get board info */
-
+
struct digi_stat {
unsigned int info_chan; /* Channel number (0 based) */
unsigned int info_brd; /* Board number (0 based) */
@@ -299,7 +299,7 @@ struct digi_ch {
};
/*
-* This structure is used with the DIGI_FEPCMD ioctl to
+* This structure is used with the DIGI_FEPCMD ioctl to
* tell the driver which port to send the command for.
*/
struct digi_cmd {
--
1.8.5.2.309.ga25014b
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
