Re: [RFC PATCH v2] staging: imx-hdmi: use rx sense status for plug detection if hpd is unreliable

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jan 10, 2014 at 03:22:24PM +0100, Philipp Zabel wrote:
> Due to the voltage divider on the HPD line, the HDMI connector on
> imx6q-sabrelite doesn't reliably detect connected DVI monitors.
> This patch allows to use the RX_SENSE0 signal as a workaround when
> enabled by a boolean device tree property 'hpd-unreliable'.

Yay, much nicer, easier to read, and smaller, thanks.  I'll add it to the
series.

I don't think we've had David Airlie's eyes on the series yet (but then
I think he's rather Rob Clark looked at non-x86 DRM stuff).  Also I've
yet to hear back from Greg wrt the component stuff, so I suspect this
series won't be making this merge window.

-- 
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel




[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux