This patch removes the struct board_t. This struct
was replaced with dgnc_board in a previous patch.
Signed-off-by: Lidza Louina <lidza.louina@xxxxxxxxx>
---
drivers/staging/dgnc/dgnc_driver.h | 85 --------------------------------------
1 file changed, 85 deletions(-)
diff --git a/drivers/staging/dgnc/dgnc_driver.h b/drivers/staging/dgnc/dgnc_driver.h
index 3d0394d..d4a830b 100644
--- a/drivers/staging/dgnc/dgnc_driver.h
+++ b/drivers/staging/dgnc/dgnc_driver.h
@@ -282,91 +282,6 @@ struct board_ops {
/*
* Per-board information
*/
-struct board_t {
- int magic; /* Board Magic number. */
- int boardnum; /* Board number: 0-32 */
-
- int type; /* Type of board */
- char *name; /* Product Name */
- struct pci_dev *pdev; /* Pointer to the pci_dev struct */
- unsigned long bd_flags; /* Board flags */
- u16 vendor; /* PCI vendor ID */
- u16 device; /* PCI device ID */
- u16 subvendor; /* PCI subsystem vendor ID */
- u16 subdevice; /* PCI subsystem device ID */
- uchar rev; /* PCI revision ID */
- uint pci_bus; /* PCI bus value */
- uint pci_slot; /* PCI slot value */
- uint maxports; /* MAX ports this board can handle */
- uchar dvid; /* Board specific device id */
- uchar vpd[128]; /* VPD of board, if found */
- uchar serial_num[20]; /* Serial number of board, if found in VPD */
-
- spinlock_t bd_lock; /* Used to protect board */
-
- spinlock_t bd_intr_lock; /* Used to protect the poller tasklet and
- * the interrupt routine from each other.
- */
-
- uint state; /* State of card. */
- wait_queue_head_t state_wait; /* Place to sleep on for state change */
-
- struct tasklet_struct helper_tasklet; /* Poll helper tasklet */
-
- uint nasync; /* Number of ports on card */
-
- uint irq; /* Interrupt request number */
- ulong intr_count; /* Count of interrupts */
- ulong intr_modem; /* Count of interrupts */
- ulong intr_tx; /* Count of interrupts */
- ulong intr_rx; /* Count of interrupts */
-
- ulong membase; /* Start of base memory of the card */
- ulong membase_end; /* End of base memory of the card */
-
- u8 __iomem *re_map_membase;/* Remapped memory of the card */
-
- ulong iobase; /* Start of io base of the card */
- ulong iobase_end; /* End of io base of the card */
-
- uint bd_uart_offset; /* Space between each UART */
-
- struct channel_t *channels[MAXPORTS]; /* array of pointers to our channels. */
-
- struct tty_driver SerialDriver;
- char SerialName[200];
- struct tty_driver PrintDriver;
- char PrintName[200];
-
- uint dgnc_Major_Serial_Registered;
- uint dgnc_Major_TransparentPrint_Registered;
-
- uint dgnc_Serial_Major;
- uint dgnc_TransparentPrint_Major;
-
- uint TtyRefCnt;
-
- char *flipbuf; /* Our flip buffer, alloced if board is found */
-
- u16 dpatype; /* The board "type", as defined by DPA */
- u16 dpastatus; /* The board "status", as defined by DPA */
-
- /*
- * Mgmt data.
- */
- char *msgbuf_head;
- char *msgbuf;
-
- uint bd_dividend; /* Board/UARTs specific dividend */
-
- struct board_ops *bd_ops;
-
- /* /proc/<board> entries */
- struct proc_dir_entry *proc_entry_pointer;
- struct dgnc_proc_entry *dgnc_board_table;
-
-};
-
struct dgnc_board {
int magic; /* Board Magic number. */
int boardnum; /* Board number: 0-32 */
--
1.8.1.2
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
