All the RTC dma support code in this driver is #ifdef'ed out.
Remove the unused code to assist in cleaning up this driver.
Signed-off-by: H Hartley Sweeten <hsweeten@xxxxxxxxxxxxxxxxxxx>
Cc: Ian Abbott <abbotti@xxxxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxx>
---
drivers/staging/comedi/drivers/pcl816.c | 146 +++-----------------------------
1 file changed, 11 insertions(+), 135 deletions(-)
diff --git a/drivers/staging/comedi/drivers/pcl816.c b/drivers/staging/comedi/drivers/pcl816.c
index 10e0960..91bd207 100644
--- a/drivers/staging/comedi/drivers/pcl816.c
+++ b/drivers/staging/comedi/drivers/pcl816.c
@@ -35,10 +35,10 @@ Configuration Options:
#include "../comedidev.h"
#include <linux/ioport.h>
-#include <linux/mc146818rtc.h>
#include <linux/gfp.h>
#include <linux/delay.h>
#include <linux/io.h>
+#include <linux/interrupt.h>
#include <asm/dma.h>
#include "comedi_fc.h"
@@ -82,14 +82,6 @@ Configuration Options:
#define INT_TYPE_AI1_DMA 2
#define INT_TYPE_AI3_INT 4
#define INT_TYPE_AI3_DMA 5
-#ifdef unused
-#define INT_TYPE_AI1_DMA_RTC 9
-#define INT_TYPE_AI3_DMA_RTC 10
-
-/* RTC stuff... */
-#define RTC_IRQ 8
-#define RTC_IO_EXTENT 0x10
-#endif
#define MAGIC_DMA_WORD 0x5a5a
@@ -126,26 +118,14 @@ struct pcl816_board {
int i8254_osc_base; /* 1/frequency of on board oscilator in ns */
};
-#ifdef unused
-static int RTC_lock; /* RTC lock */
-static int RTC_timer_lock; /* RTC int lock */
-#endif
-
struct pcl816_private {
unsigned int dma; /* used DMA, 0=don't use DMA */
- int dma_rtc; /* 1=RTC used with DMA, 0=no RTC alloc */
-#ifdef unused
- unsigned long rtc_iobase; /* RTC port region */
- unsigned int rtc_iosize;
- unsigned int rtc_irq;
-#endif
unsigned long dmabuf[2]; /* pointers to begin of DMA buffers */
unsigned int dmapages[2]; /* len of DMA buffers in PAGE_SIZEs */
unsigned int hwdmaptr[2]; /* hardware address of DMA buffers */
unsigned int hwdmasize[2]; /* len of DMA buffers in Bytes */
unsigned int dmasamplsize; /* size in samples hwdmasize[0]/2 */
- unsigned int last_top_dma; /* DMA pointer in last RTC int */
int next_dma_buf; /* which DMA buffer will be used next round */
long dma_runs_to_end; /* how many we must permorm DMA transfer to end of record */
unsigned long last_dma_run; /* how many bytes we must transfer on last DMA page */
@@ -154,9 +134,6 @@ struct pcl816_private {
unsigned char ai_neverending; /* if=1, then we do neverending record (you must use cancel()) */
int irq_free; /* 1=have allocated IRQ */
int irq_blocked; /* 1=IRQ now uses any subdev */
-#ifdef unused
- int rtc_irq_blocked; /* 1=we now do AI with DMA&RTC */
-#endif
int irq_was_now_closed; /* when IRQ finish, there's stored int816_mode for last interrupt */
int int816_mode; /* who now uses IRQ - 1=AI1 int, 2=AI1 dma, 3=AI3 int, 4AI3 dma */
struct comedi_subdevice *last_int_sub; /* ptr to subdevice which now finish */
@@ -167,10 +144,6 @@ struct pcl816_private {
unsigned int ai_n_chan; /* how many channels per scan */
unsigned int ai_poll_ptr; /* how many sampes transfer poll */
struct comedi_subdevice *sub_ai; /* ptr to AI subdevice */
-#ifdef unused
- struct timer_list rtc_irq_timer; /* timer for RTC sanity check */
- unsigned long rtc_freq; /* RTC int freq */
-#endif
};
/*
@@ -186,9 +159,6 @@ static int pcl816_ai_cancel(struct comedi_device *dev,
struct comedi_subdevice *s);
static void start_pacer(struct comedi_device *dev, int mode,
unsigned int divisor1, unsigned int divisor2);
-#ifdef unused
-static int set_rtc_irq_bit(unsigned char bit);
-#endif
static int pcl816_ai_cmdtest(struct comedi_device *dev,
struct comedi_subdevice *s,
@@ -718,12 +688,6 @@ static int pcl816_ai_cancel(struct comedi_device *dev,
if (devpriv->irq_blocked > 0) {
switch (devpriv->int816_mode) {
-#ifdef unused
- case INT_TYPE_AI1_DMA_RTC:
- case INT_TYPE_AI3_DMA_RTC:
- set_rtc_irq_bit(0); /* stop RTC */
- del_timer(&devpriv->rtc_irq_timer);
-#endif
case INT_TYPE_AI1_DMA:
case INT_TYPE_AI3_DMA:
disable_dma(devpriv->dma);
@@ -939,43 +903,6 @@ setup_channel_list(struct comedi_device *dev,
dev->iobase + PCL816_MUX);
}
-#ifdef unused
-/*
-==============================================================================
- Enable(1)/disable(0) periodic interrupts from RTC
-*/
-static int set_rtc_irq_bit(unsigned char bit)
-{
- unsigned char val;
- unsigned long flags;
-
- if (bit == 1) {
- RTC_timer_lock++;
- if (RTC_timer_lock > 1)
- return 0;
- } else {
- RTC_timer_lock--;
- if (RTC_timer_lock < 0)
- RTC_timer_lock = 0;
- if (RTC_timer_lock > 0)
- return 0;
- }
-
- save_flags(flags);
- cli();
- val = CMOS_READ(RTC_CONTROL);
- if (bit)
- val |= RTC_PIE;
- else
- val &= ~RTC_PIE;
-
- CMOS_WRITE(val, RTC_CONTROL);
- CMOS_READ(RTC_INTR_FLAGS);
- restore_flags(flags);
- return 0;
-}
-#endif
-
static int pcl816_attach(struct comedi_device *dev, struct comedi_devconfig *it)
{
const struct pcl816_board *board = comedi_board(dev);
@@ -1033,47 +960,10 @@ static int pcl816_attach(struct comedi_device *dev, struct comedi_devconfig *it)
devpriv->irq_blocked = 0; /* number of subdevice which use IRQ */
devpriv->int816_mode = 0; /* mode of irq */
-#ifdef unused
- /* grab RTC for DMA operations */
- devpriv->dma_rtc = 0;
- if (it->options[2] > 0) { /* we want to use DMA */
- if (RTC_lock == 0) {
- ret = __comedi_request_region(dev, RTC_PORT(0),
- RTC_IO_EXTENT);
- if (ret)
- goto no_rtc;
- }
- devpriv->rtc_iobase = RTC_PORT(0);
- devpriv->rtc_iosize = RTC_IO_EXTENT;
- RTC_lock++;
-#ifdef UNTESTED_CODE
- if (!request_irq(RTC_IRQ, interrupt_pcl816_ai_mode13_dma_rtc, 0,
- "pcl816 DMA (RTC)", dev)) {
- devpriv->dma_rtc = 1;
- devpriv->rtc_irq = RTC_IRQ;
- printk(", dma_irq=%u", devpriv->rtc_irq);
- } else {
- RTC_lock--;
- if (RTC_lock == 0) {
- if (devpriv->rtc_iobase)
- release_region(devpriv->rtc_iobase,
- devpriv->rtc_iosize);
- }
- devpriv->rtc_iobase = 0;
- devpriv->rtc_iosize = 0;
- }
-#else
- printk("pcl816: RTC code missing");
-#endif
-
- }
-
-no_rtc:
-#endif
/* grab our DMA */
dma = 0;
devpriv->dma = dma;
- if ((devpriv->irq_free == 0) && (devpriv->dma_rtc == 0))
+ if (!devpriv->irq_free)
goto no_dma; /* if we haven't IRQ, we can't use DMA */
if (board->DMAbits != 0) { /* board support DMA */
@@ -1110,19 +1000,16 @@ no_rtc:
devpriv->hwdmasize[0] = (1 << pages) * PAGE_SIZE;
/* printk("%d %d %ld, ",devpriv->dmapages[0],devpriv->hwdmasize[0],PAGE_SIZE); */
- if (devpriv->dma_rtc == 0) { /* we must do duble buff :-( */
- devpriv->dmabuf[1] = __get_dma_pages(GFP_KERNEL, pages);
- if (!devpriv->dmabuf[1]) {
- printk(KERN_ERR
- ", unable to allocate DMA buffer, "
- "FAIL!\n");
- return -EBUSY;
- }
- devpriv->dmapages[1] = pages;
- devpriv->hwdmaptr[1] =
- virt_to_bus((void *)devpriv->dmabuf[1]);
- devpriv->hwdmasize[1] = (1 << pages) * PAGE_SIZE;
+ devpriv->dmabuf[1] = __get_dma_pages(GFP_KERNEL, pages);
+ if (!devpriv->dmabuf[1]) {
+ printk(KERN_ERR
+ ", unable to allocate DMA buffer, "
+ "FAIL!\n");
+ return -EBUSY;
}
+ devpriv->dmapages[1] = pages;
+ devpriv->hwdmaptr[1] = virt_to_bus((void *)devpriv->dmabuf[1]);
+ devpriv->hwdmasize[1] = (1 << pages) * PAGE_SIZE;
}
no_dma:
@@ -1206,17 +1093,6 @@ static void pcl816_detach(struct comedi_device *dev)
free_pages(devpriv->dmabuf[0], devpriv->dmapages[0]);
if (devpriv->dmabuf[1])
free_pages(devpriv->dmabuf[1], devpriv->dmapages[1]);
-#ifdef unused
- if (devpriv->rtc_irq)
- free_irq(devpriv->rtc_irq, dev);
- if ((devpriv->dma_rtc) && (RTC_lock == 1)) {
- if (devpriv->rtc_iobase)
- release_region(devpriv->rtc_iobase,
- devpriv->rtc_iosize);
- }
- if (devpriv->dma_rtc)
- RTC_lock--;
-#endif
}
comedi_legacy_detach(dev);
}
--
1.8.1.4
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
