lirc uses the CONFIG_SA1100_BITSY Kconfig macro. But its Kconfig symbol
was removed in v2.4.13. So we can remove a few lines of dead code.
Signed-off-by: Paul Bolle <pebolle@xxxxxxxxxx>
---
Untested, but of rather low risk. Note that support for the
machine_is_bitsy() macro was already removed in v2.4.10.
drivers/staging/media/lirc/lirc_sir.c | 10 ----------
1 file changed, 10 deletions(-)
diff --git a/drivers/staging/media/lirc/lirc_sir.c b/drivers/staging/media/lirc/lirc_sir.c
index 63a554c..f781c53 100644
--- a/drivers/staging/media/lirc/lirc_sir.c
+++ b/drivers/staging/media/lirc/lirc_sir.c
@@ -787,12 +787,6 @@ static int init_hardware(void)
spin_lock_irqsave(&hardware_lock, flags);
/* reset UART */
#ifdef LIRC_ON_SA1100
-#ifdef CONFIG_SA1100_BITSY
- if (machine_is_bitsy()) {
- pr_info("Power on IR module\n");
- set_bitsy_egpio(EGPIO_BITSY_IR_ON);
- }
-#endif
#ifdef CONFIG_SA1100_COLLIE
sa1100_irda_set_power_collie(3); /* power on */
#endif
@@ -942,10 +936,6 @@ static void drop_hardware(void)
Ser2UTCR3 = sr.utcr3;
Ser2HSCR0 = sr.hscr0;
-#ifdef CONFIG_SA1100_BITSY
- if (machine_is_bitsy())
- clr_bitsy_egpio(EGPIO_BITSY_IR_ON);
-#endif
#ifdef CONFIG_SA1100_COLLIE
sa1100_irda_set_power_collie(0); /* power off */
#endif
--
1.7.11.7
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
