This variable is never used in the driver. Just remove it.
Signed-off-by: H Hartley Sweeten <hsweeten@xxxxxxxxxxxxxxxxxxx>
Cc: Ian Abbott <abbotti@xxxxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/staging/comedi/drivers/s626.c | 7 -------
1 file changed, 7 deletions(-)
diff --git a/drivers/staging/comedi/drivers/s626.c b/drivers/staging/comedi/drivers/s626.c
index 4eb1a67..0b89737 100644
--- a/drivers/staging/comedi/drivers/s626.c
+++ b/drivers/staging/comedi/drivers/s626.c
@@ -99,7 +99,6 @@ struct s626_private {
uint16_t Dacpol; /* Image of DAC polarity register. */
uint8_t TrimSetpoint[12]; /* Images of TrimDAC setpoints */
/* Charge Enabled (0 or WRMISC2_CHARGE_ENABLE). */
- uint16_t WDInterval; /* Image of MISC2 watchdog interval control bits. */
uint32_t I2CAdrs;
/* I2C device address for onboard EEPROM (board rev dependent). */
/* short I2Cards; */
@@ -2666,12 +2665,6 @@ static void s626_initialize(struct comedi_device *dev)
for (chan = 0; chan < S626_DAC_CHANNELS; chan++)
SetDAC(dev, chan, 0);
- /* Init image of watchdog timer interval in WRMISC2. This image
- * maintains the value of the control bits of MISC2 are
- * continuously reset to zero as long as the WD timer is disabled.
- */
- devpriv->WDInterval = 0;
-
/* Init Counter Interrupt enab mask for RDMISC2. This mask is
* applied against MISC2 when testing to determine which timer
* events are requesting interrupt service.
--
1.7.11
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
