On Tue, 2012-09-18 at 15:34 +0200, Joerg Roedel wrote: > On Mon, Sep 17, 2012 at 04:45:15PM -0600, Shuah Khan wrote: > > Yeah. I will firm up my ideas a bit and summarize in a day or two. Would > > like to hear your ideas as well at that time, so we can pick the one > > that works the best. > > I think the best approach for this functionality is to add a flag to > 'struct dma_debug_entry' which tells whether the address has been > checked with dma_mapping error or not. On unmap or driver unload you can > then check for that flag and print a warning when an unchecked address > is detected. Was hoping to get comments from you as well. You are original author for this dam-debug module. Are you ok with the system wide and per device error counts I added? Any comments on the overall approach? The approach you suggested will cover the cases where drivers fail to check good map cases. We won't able to catch failed maps that get used without checks. Are you not concerned about these cases? These could cause a silent error with wild writes or could bring the system down. Or are you recommending changing the infrastructure to track failed maps as well? I am still pursuing a way to track failed map cases. I combined the flag idea with one of the ideas I am looking into. Details below: (if this sounds like a reasonable approach, I can do v2 patch and we can discuss the code) . Add new fields dma_map_errors, dma_map_errors_not_checked, dma_unmap_errors, iotlb_overflow_cnt, and flag to struct dma_debug_entry. Maybe flag is not even needed if dma_map_errors_not_checked can double as status. . Enhance dma_debug_init() to create a second table to track failed maps with PREALLOC_DMA_DEBUG_ENTRIES/64 = 64. 64 devices probably is good enough. . Entries added to this new table when debug_dma_map_page() detects error when mapping error is detected for the first time. Subsequent errors, will increment dma_map_errors, dma_map_errors_not_checked for that the device that is tracked by this entry. Note: paddr field could work as an index into this table (existing table uses dma_addr) . Decrement dma_map_errors_not_checked from debug_dma_mapping_error(), clear the flag. . check_unmap() when it detects mapping error, checks flag (status) and prints warn message. -- Shuah _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
