Removed some old comments and a few blank lines
Signed-off-by: Andrew Miller <amiller@xxxxxxxxx>
---
drivers/staging/rtl8187se/r8185b_init.c | 24 ++----------------------
1 files changed, 2 insertions(+), 22 deletions(-)
diff --git a/drivers/staging/rtl8187se/r8185b_init.c b/drivers/staging/rtl8187se/r8185b_init.c
index 3f9be9b..d90cf10 100644
--- a/drivers/staging/rtl8187se/r8185b_init.c
+++ b/drivers/staging/rtl8187se/r8185b_init.c
@@ -25,13 +25,10 @@ Notes:
#include "r8180_rtl8225.h" /* RTL8225 Radio frontend */
#include "r8180_93cx6.h" /* Card EEPROM */
#include "r8180_wx.h"
-
#include "ieee80211/dot11d.h"
-
-
/* #define CONFIG_RTL8180_IO_MAP */
-
#define TC_3W_POLL_MAX_TRY_CNT 5
+
static u8 MAC_REG_TABLE[][2] = {
/*PAGA 0: */
/* 0x34(BRSR), 0xBE(RATE_FALLBACK_CTL), 0x1E0(ARFR) would set in HwConfigureRTL8185() */
@@ -133,7 +130,6 @@ u8 PlatformIORead1Byte(struct net_device *dev, u32 offset);
void PlatformIOWrite4Byte(struct net_device *dev, u32 offset, u32 data)
{
-/* {by amy 080312 */
if (offset == PhyAddr) {
/* For Base Band configuration. */
unsigned char cmdByte;
@@ -169,9 +165,7 @@ void PlatformIOWrite4Byte(struct net_device *dev, u32 offset, u32 data)
write_nic_byte(dev, offset, cmdByte);
/* NdisReleaseSpinLock( &(pDevice->IoSpinLock) ); */
- }
-/* by amy 080312} */
- else {
+ } else {
write_nic_dword(dev, offset, data);
read_nic_dword(dev, offset); /* To make sure write operation is completed, 2005.11.09, by rcnjko. */
}
@@ -393,7 +387,6 @@ u8 ReadBBPortUchar(struct net_device *dev, u32 addr)
return RegisterContent;
}
-/* {by amy 080312 */
/*
Description:
Perform Antenna settings with antenna diversity on 87SE.
@@ -465,7 +458,6 @@ bool SetAntennaConfig87SE(struct net_device *dev,
priv->CurrAntennaIndex = DefaultAnt; /* Update default settings. */
return bAntennaSwitched;
}
-/* by amy 080312 */
/*
---------------------------------------------------------------
* Hardware Initialization.
@@ -583,7 +575,6 @@ void ZEBRA_Config_85BASIC_HardCode(struct net_device *dev)
/* DAC calibration off 20070702 */
RF_WriteReg(dev, 0x06, 0x00c1); mdelay(1);
RF_WriteReg(dev, 0x0a, 0x0001); mdelay(1);
-/* {by amy 080312 */
/* For crystal calibration, added by Roger, 2007.12.11. */
if (priv->bXtalCalibration) { /* reg 30. */
/* enable crystal calibration.
@@ -598,7 +589,6 @@ void ZEBRA_Config_85BASIC_HardCode(struct net_device *dev)
/* using default value. Xin=6, Xout=6. */
RF_WriteReg(dev, 0x0f, 0x0acc); mdelay(1);
}
-/* by amy 080312 */
RF_WriteReg(dev, 0x00, 0x00bf); mdelay(1); /* switch to reg0-reg15, and HSSI enable */
RF_WriteReg(dev, 0x0d, 0x08df); mdelay(1); /* Rx BB start calibration, 00c//+edward */
@@ -692,11 +682,8 @@ void ZEBRA_Config_85BASIC_HardCode(struct net_device *dev)
by amy for antenna
=============================================================================
*/
-/* {by amy 080312 */
/* Config Sw/Hw Combinational Antenna Diversity. Added by Roger, 2008.02.26. */
SetAntennaConfig87SE(dev, priv->bDefaultAntenna1, priv->bSwAntennaDiverity);
-/* by amy 080312} */
-/* by amy for antenna */
}
@@ -792,7 +779,6 @@ void PhyConfig8185(struct net_device *dev)
priv->RFProgType = read_nic_byte(dev, CONFIG4) & 0x03;
/* RF config */
ZEBRA_Config_85BASIC_HardCode(dev);
-/* {by amy 080312 */
/* Set default initial gain state to 4, approved by SD3 DZ, by Bruce, 2007-06-06. */
if (priv->bDigMechanism) {
if (priv->InitialGain == 0)
@@ -807,7 +793,6 @@ void PhyConfig8185(struct net_device *dev)
if (priv->bTxPowerTrack)
InitTxPwrTracking87SE(dev);
-/* by amy 080312} */
priv->InitialGainBackUp = priv->InitialGain;
UpdateInitialGain(dev);
@@ -1055,7 +1040,6 @@ void ActUpdateChannelAccessSetting(struct net_device *dev,
PACI_AIFSN pAciAifsn = (PACI_AIFSN)(&pAcParam->f.AciAifsn);
AC_CODING eACI = pAciAifsn->f.ACI;
- /*modified Joseph */
/*for 8187B AsynIORead issue */
u8 AcmCtrl = 0;
if (pAciAifsn->f.ACM) {
@@ -1158,7 +1142,6 @@ void rtl8185b_irq_enable(struct net_device *dev)
write_nic_dword(dev, IMR, priv->IntrMask);
}
-/* by amy for power save */
void DrvIFIndicateDisassociation(struct net_device *dev, u16 reason)
{
/* nothing is needed after disassociation request. */
@@ -1565,7 +1548,6 @@ void rtl8185b_adapter_start(struct net_device *dev)
/* One of B, G, A. */
InitWirelessMode = ieee->mode;
}
-/* by amy for power save */
priv->eRFPowerState = eRfOff;
priv->RfOffReason = 0;
{
@@ -1577,8 +1559,6 @@ void rtl8185b_adapter_start(struct net_device *dev)
if (priv->bInactivePs)
MgntActSet_RF_State(dev , eRfOff, RF_CHANGE_BY_IPS);
-/* by amy for power save */
-
ActSetWirelessMode8185(dev, (u8)(InitWirelessMode));
/* ----------------------------------------------------------------------------- */
--
1.7.7.6
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
