Mark Einon <mark.einon@xxxxxxxxx> :
> Added basic suspend & resume functionality.
> Tested on an et1310 device, and putting Fedora15 host in and out of
> hibernation successfully.
>
> Signed-off-by: Mark Einon <mark.einon@xxxxxxxxx>
[...]
> diff --git a/drivers/staging/et131x/et131x_initpci.c b/drivers/staging/et131x/et131x_initpci.c
> index 10283a3..e166fde 100644
> --- a/drivers/staging/et131x/et131x_initpci.c
> +++ b/drivers/staging/et131x/et131x_initpci.c
> @@ -869,6 +869,45 @@ static void __devexit et131x_pci_remove(struct pci_dev *pdev)
> pci_disable_device(pdev);
> }
>
> +static int et131x_pci_suspend(struct pci_dev *pdev, pm_message_t state)
> +{
> + struct net_device *netdev = pci_get_drvdata(pdev);
> +
> + if (!netif_running(netdev))
> + return 0;
> +
> + et131x_close(netdev);
> + netif_device_detach(netdev);
> +
> + pci_save_state(pdev);
> + pci_set_power_state(pdev, pci_choose_state(pdev, state));
> +
> + return 0;
> +}
> +
> +static int et131x_pci_resume(struct pci_dev *pdev)
> +{
> + struct net_device *netdev = pci_get_drvdata(pdev);
> + int err = 0;
> +
> + if (!netif_running(netdev))
> + return 0;
> +
> + pci_set_power_state(pdev, PCI_D0);
> + pci_restore_state(pdev);
> +
> + err = et131x_open(netdev);
> + if (err) {
> + dev_err(&pdev->dev, "Can't resume interface!\n");
> + goto out;
> + }
You can/should split et131x_{open/close} to remove this failure point.
[...]
> @@ -884,8 +923,10 @@ static struct pci_driver et131x_driver = {
> .id_table = et131x_pci_table,
> .probe = et131x_pci_setup,
> .remove = __devexit_p(et131x_pci_remove),
> - .suspend = NULL, /* et131x_pci_suspend */
> - .resume = NULL, /* et131x_pci_resume */
> +#ifdef CONFIG_PM
> + .suspend = et131x_pci_suspend,
> + .resume = et131x_pci_resume,
> +#endif
There is not much driver specific there. It should probably go through
pci_driver.driver.pm.
--
Ueimor
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
