The ai_force settings were used to set the ethernet speed and duplex manually.
This is now being done by the phy_device, so remove.
Signed-off-by: Mark Einon <mark.einon@xxxxxxxxx>
---
drivers/staging/et131x/et1310_phy.c | 6 ++----
drivers/staging/et131x/et131x_adapter.h | 2 --
2 files changed, 2 insertions(+), 6 deletions(-)
diff --git a/drivers/staging/et131x/et1310_phy.c b/drivers/staging/et131x/et1310_phy.c
index 3c82f44..c4bc41d 100644
--- a/drivers/staging/et131x/et1310_phy.c
+++ b/drivers/staging/et131x/et1310_phy.c
@@ -498,10 +498,8 @@ void et131x_mii_check(struct et131x_adapter *adapter,
}
}
- if ((bmsr_ints & BMSR_ANEGCOMPLETE) ||
- (adapter->ai_force_duplex == 3 && (bmsr_ints & BMSR_LSTATUS))) {
- if ((bmsr & BMSR_ANEGCOMPLETE) ||
- adapter->ai_force_duplex == 3) {
+ if (bmsr_ints & BMSR_ANEGCOMPLETE) {
+ if (bmsr & BMSR_ANEGCOMPLETE) {
et1310_phy_link_status(adapter,
&link_status, &autoneg_status,
&speed, &duplex, &mdi_mdix,
diff --git a/drivers/staging/et131x/et131x_adapter.h b/drivers/staging/et131x/et131x_adapter.h
index 292a771..78f2894 100644
--- a/drivers/staging/et131x/et131x_adapter.h
+++ b/drivers/staging/et131x/et131x_adapter.h
@@ -181,8 +181,6 @@ struct et131x_adapter {
u32 registry_jumbo_packet; /* Max supported ethernet packet size */
/* Derived from the registry: */
- u8 ai_force_duplex; /* duplex setting */
- u16 ai_force_speed; /* 'Speed', user over-ride of line speed */
u8 flowcontrol; /* flow control validated by the far-end */
/* Minimize init-time */
--
1.7.6
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
