Substituted/removed macro's.
Reported-by: Johannes Berg <johannes@xxxxxxxxxxxxxxxx>
Reviewed-by: Pieter-Paul Giesberts <pieterpg@xxxxxxxxxxxx>
Reviewed-by: Arend van Spriel <arend@xxxxxxxxxxxx>
Signed-off-by: Roland Vossen <rvossen@xxxxxxxxxxxx>
---
drivers/staging/brcm80211/brcmsmac/main.c | 18 ++++++++++
drivers/staging/brcm80211/brcmsmac/main.h | 1 -
drivers/staging/brcm80211/brcmsmac/otp.c | 5 ++-
drivers/staging/brcm80211/brcmsmac/otp.h | 6 ---
drivers/staging/brcm80211/brcmsmac/pmu.h | 13 --------
drivers/staging/brcm80211/brcmsmac/pub.h | 49 -----------------------------
6 files changed, 21 insertions(+), 71 deletions(-)
diff --git a/drivers/staging/brcm80211/brcmsmac/main.c b/drivers/staging/brcm80211/brcmsmac/main.c
index 9e73b42..fff3ba9 100644
--- a/drivers/staging/brcm80211/brcmsmac/main.c
+++ b/drivers/staging/brcm80211/brcmsmac/main.c
@@ -267,6 +267,20 @@
#define APHY_SLOT_TIME 9
#define BPHY_SLOT_TIME 20
+#define WL_SPURAVOID_OFF 0
+#define WL_SPURAVOID_ON1 1
+#define WL_SPURAVOID_ON2 2
+
+/*
+ * 32 SSID chars, max of 4 chars for each SSID char "\xFF", plus NULL.
+ */
+#define SSID_FMT_BUF_LEN ((4 * IEEE80211_MAX_SSID_LEN) + 1)
+
+/* defaults for the HT (MIMO) bss */
+#define HT_CAP (IEEE80211_HT_CAP_SM_PS |\
+ IEEE80211_HT_CAP_SUP_WIDTH_20_40 | IEEE80211_HT_CAP_GRN_FLD |\
+ IEEE80211_HT_CAP_MAX_AMSDU | IEEE80211_HT_CAP_DSSSCCK40)
+
/*
* The following table lists the buffer memory allocated to xmt fifos in HW.
* the size is in units of 256bytes(one block), total size is HW dependent
@@ -361,6 +375,10 @@
#define IS_MBAND_UNLOCKED(wlc) \
((wlc->pub->_nbands > 1) && !(wlc)->bandlocked)
+#define CHSPEC_WLC_BW(chanspec) (CHSPEC_IS40(chanspec) ? BRCMS_40_MHZ : \
+ CHSPEC_IS20(chanspec) ? BRCMS_20_MHZ : \
+ BRCMS_10_MHZ)
+
/* dup state between BMAC(struct brcms_hardware) and HIGH(struct brcms_c_info)
driver */
struct brcms_b_state {
diff --git a/drivers/staging/brcm80211/brcmsmac/main.h b/drivers/staging/brcm80211/brcmsmac/main.h
index e8a854b..047c422 100644
--- a/drivers/staging/brcm80211/brcmsmac/main.h
+++ b/drivers/staging/brcm80211/brcmsmac/main.h
@@ -23,7 +23,6 @@
#include "types.h"
#include "d11.h"
-#define MA_WINDOW_SZ 8 /* moving average window size */
#define INVCHANNEL 255 /* invalid channel */
/* max # brcms_c_module_register() calls */
diff --git a/drivers/staging/brcm80211/brcmsmac/otp.c b/drivers/staging/brcm80211/brcmsmac/otp.c
index 1e0093c..05c78c7 100644
--- a/drivers/staging/brcm80211/brcmsmac/otp.c
+++ b/drivers/staging/brcm80211/brcmsmac/otp.c
@@ -64,6 +64,9 @@
#define MAXNUMRDES 9 /* Maximum OTP redundancy entries */
+/* Fixed size subregions sizes in words */
+#define OTPGU_CI_SZ 2
+
/* OTP function struct */
struct otp_fn_s {
int (*size)(struct otpinfo *oi);
@@ -111,8 +114,6 @@ static struct otpinfo otpinfo;
*
*/
-#define HWSW_RGN(rgn) (((rgn) == OTP_HW_RGN) ? "h/w" : "s/w")
-
/* OTP layout */
/* CC revs 21, 24 and 27 OTP General Use Region word offset */
#define REVA4_OTPGU_BASE 12
diff --git a/drivers/staging/brcm80211/brcmsmac/otp.h b/drivers/staging/brcm80211/brcmsmac/otp.h
index 938100e..bf2f76f 100644
--- a/drivers/staging/brcm80211/brcmsmac/otp.h
+++ b/drivers/staging/brcm80211/brcmsmac/otp.h
@@ -30,12 +30,6 @@
/* OTP Size */
#define OTP_SZ_MAX (6144/8) /* maximum bytes in one CIS */
-/* Fixed size subregions sizes in words */
-#define OTPGU_CI_SZ 2
-
-/* OTP usage */
-#define OTP4325_FM_DISABLED_OFFSET 188
-
struct otpinfo;
/* Exported functions */
diff --git a/drivers/staging/brcm80211/brcmsmac/pmu.h b/drivers/staging/brcm80211/brcmsmac/pmu.h
index 0c7e48c..2917e6f 100644
--- a/drivers/staging/brcm80211/brcmsmac/pmu.h
+++ b/drivers/staging/brcm80211/brcmsmac/pmu.h
@@ -19,19 +19,6 @@
#define _BRCM_PMU_H_
#include "types.h"
-/*
- * LDO selections used in si_pmu_set_ldo_voltage
- */
-#define SET_LDO_VOLTAGE_LDO1 1
-#define SET_LDO_VOLTAGE_LDO2 2
-#define SET_LDO_VOLTAGE_LDO3 3
-#define SET_LDO_VOLTAGE_PAREF 4
-#define SET_LDO_VOLTAGE_CLDO_PWM 5
-#define SET_LDO_VOLTAGE_CLDO_BURST 6
-#define SET_LDO_VOLTAGE_CBUCK_PWM 7
-#define SET_LDO_VOLTAGE_CBUCK_BURST 8
-#define SET_LDO_VOLTAGE_LNLDO1 9
-#define SET_LDO_VOLTAGE_LNLDO2_SEL 10
extern u16 si_pmu_fast_pwrup_delay(struct si_pub *sih);
extern void si_pmu_sprom_enable(struct si_pub *sih, bool enable);
diff --git a/drivers/staging/brcm80211/brcmsmac/pub.h b/drivers/staging/brcm80211/brcmsmac/pub.h
index 5bca2fb..ab2fb11 100644
--- a/drivers/staging/brcm80211/brcmsmac/pub.h
+++ b/drivers/staging/brcm80211/brcmsmac/pub.h
@@ -40,10 +40,6 @@
#define BRCMS_20_MHZ 20 /* 20Mhz nphy channel bandwidth */
#define BRCMS_40_MHZ 40 /* 40Mhz nphy channel bandwidth */
-#define CHSPEC_WLC_BW(chanspec) (CHSPEC_IS40(chanspec) ? BRCMS_40_MHZ : \
- CHSPEC_IS20(chanspec) ? BRCMS_20_MHZ : \
- BRCMS_10_MHZ)
-
#define BRCMS_RSSI_MINVAL -200 /* Low value, e.g. for forcing roam */
#define BRCMS_RSSI_NO_SIGNAL -91 /* NDIS RSSI link quality cutoffs */
#define BRCMS_RSSI_VERY_LOW -80 /* Very low quality cutoffs */
@@ -52,13 +48,6 @@
#define BRCMS_RSSI_VERY_GOOD -58 /* Very good quality cutoffs */
#define BRCMS_RSSI_EXCELLENT -57 /* Excellent quality cutoffs */
-/* macro to perform PHY -> D11 PHY TYPE, currently 1:1 */
-#define BRCMS_PHYTYPE(_x) (_x)
-
-#define MA_WINDOW_SZ 8 /* moving average window size */
-
-#define BRCMS_SNR_INVALID 0 /* invalid SNR value */
-
/* a large TX Power as an init value to factor out of min() calculations,
* keep low enough to fit in an s8, units are .25 dBm
*/
@@ -87,9 +76,6 @@
/* driver's default tx antenna setting */
#define ANT_TX_DEF 3
-/* use all available core for transmit */
-#define TXCORE_POLICY_ALL 0x1
-
/* Tx Chain values */
/* def bitmap of txchain */
#define TXCHAIN_DEF 0x1
@@ -113,15 +99,9 @@
#define ANTSWITCH_TYPE_3 3
#define RXBUFSZ PKTBUFSZ
-/* aid bitmap size in bytes */
-#define AIDMAPSZ (roundup(MAXSCB, NBBY)/NBBY)
#define MAX_STREAMS_SUPPORTED 4 /* max number of streams supported */
-#define WL_SPURAVOID_OFF 0
-#define WL_SPURAVOID_ON1 1
-#define WL_SPURAVOID_ON2 2
-
struct brcms_tunables {
int ntxd; /* size of tx descriptor table */
int nrxd; /* size of rx descriptor table */
@@ -158,24 +138,11 @@ struct rsn_parms {
u8 PAD[4]; /* padding for future growth */
};
-/*
- * 32 SSID chars, max of 4 chars for each SSID char "\xFF", plus NULL.
- */
-#define SSID_FMT_BUF_LEN ((4 * IEEE80211_MAX_SSID_LEN) + 1)
-
-#define RSN_FLAGS_SUPPORTED 0x1 /* Flag for rsn_params */
-#define RSN_FLAGS_PREAUTH 0x2 /* Flag for WPA2 rsn_params */
-
/* All the HT-specific default advertised capabilities (including AMPDU)
* should be grouped here at one place
*/
#define AMPDU_DEF_MPDU_DENSITY 6 /* default mpdu density (110 ==> 4us) */
-/* defaults for the HT (MIMO) bss */
-#define HT_CAP (IEEE80211_HT_CAP_SM_PS |\
- IEEE80211_HT_CAP_SUP_WIDTH_20_40 | IEEE80211_HT_CAP_GRN_FLD |\
- IEEE80211_HT_CAP_MAX_AMSDU | IEEE80211_HT_CAP_DSSSCCK40)
-
/* wlc internal bss_info */
struct brcms_bss_info {
u8 BSSID[ETH_ALEN]; /* network BSSID */
@@ -202,22 +169,6 @@ struct brcms_bss_info {
u8 wpacfg; /* wpa config index */
};
-/* IOVar flags for common error checks */
-#define IOVF_MFG (1<<3) /* flag for mfgtest iovars */
-#define IOVF_WHL (1<<4) /* value must be whole (0-max) */
-#define IOVF_NTRL (1<<5) /* value must be natural (1-max) */
-
-#define IOVF_SET_UP (1<<6) /* set requires driver be up */
-#define IOVF_SET_DOWN (1<<7) /* set requires driver be down */
-#define IOVF_SET_CLK (1<<8) /* set requires core clock */
-#define IOVF_SET_BAND (1<<9) /* set requires fixed band */
-
-#define IOVF_GET_UP (1<<10) /* get requires driver be up */
-#define IOVF_GET_DOWN (1<<11) /* get requires driver be down */
-#define IOVF_GET_CLK (1<<12) /* get requires core clock */
-#define IOVF_GET_BAND (1<<13) /* get requires fixed band */
-#define IOVF_OPEN_ALLOW (1<<14) /* set allowed iovar for opensrc */
-
#define MAC80211_PROMISC_BCNS (1 << 0)
#define MAC80211_SCAN (1 << 1)
--
1.7.4.1
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
