Signed-off-by: Mairo Paul Rufus <akoudanilo@xxxxxxxxx>
---
drivers/staging/wlan-ng/p80211netdev.c | 2 +-
drivers/staging/wlan-ng/prism2mib.c | 2 +-
drivers/staging/wlan-ng/prism2sta.c | 4 ++--
3 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/staging/wlan-ng/p80211netdev.c b/drivers/staging/wlan-ng/p80211netdev.c
index 7b091c5a2984..4a6813e89916 100644
--- a/drivers/staging/wlan-ng/p80211netdev.c
+++ b/drivers/staging/wlan-ng/p80211netdev.c
@@ -274,7 +274,7 @@ static void p80211netdev_rx_bh(unsigned long arg)
struct sk_buff *skb = NULL;
struct net_device *dev = wlandev->netdev;
- /* Let's empty our our queue */
+ /* Let's empty our queue */
while ((skb = skb_dequeue(&wlandev->nsd_rxq))) {
if (wlandev->state == WLAN_DEVICE_OPEN) {
if (dev->type != ARPHRD_ETHER) {
diff --git a/drivers/staging/wlan-ng/prism2mib.c b/drivers/staging/wlan-ng/prism2mib.c
index 7d7d77b04255..875812a391c9 100644
--- a/drivers/staging/wlan-ng/prism2mib.c
+++ b/drivers/staging/wlan-ng/prism2mib.c
@@ -292,7 +292,7 @@ int prism2mgmt_mibset_mibget(struct wlandevice *wlandev, void *msgp)
/*
** Determine if this is a "mibget" or a "mibset". If this is a
** "mibget", then make sure that the MIB may be read. Otherwise,
- ** this is a "mibset" so make make sure that the MIB may be written.
+ ** this is a "mibset" so make sure that the MIB may be written.
*/
isget = (msg->msgcode == DIDMSG_DOT11REQ_MIBGET);
diff --git a/drivers/staging/wlan-ng/prism2sta.c b/drivers/staging/wlan-ng/prism2sta.c
index 8f25496188aa..e6dcb687e7a1 100644
--- a/drivers/staging/wlan-ng/prism2sta.c
+++ b/drivers/staging/wlan-ng/prism2sta.c
@@ -461,7 +461,7 @@ u32 prism2sta_ifstate(struct wlandevice *wlandev, u32 ifstate)
case WLAN_MSD_FWLOAD:
wlandev->msdstate = WLAN_MSD_RUNNING_PENDING;
/* Initialize the device+driver for full
- * operation. Note that this might me an FWLOAD to
+ * operation. Note that this might me an FWLOAD
* to RUNNING transition so we must not do a chip
* or board level reset. Note that on failure,
* the MSD state is set to HWPRESENT because we
@@ -1352,7 +1352,7 @@ void prism2sta_processing_defer(struct work_struct *data)
* we get back in range. We should block transmits and
* receives in this state. Do we need an indication here?
* Probably not since a polling user-mode element would
- * get this status from from p2PortStatus(FD40). What about
+ * get this status from p2PortStatus(FD40). What about
* p80211?
* Response:
* Block Transmits, Ignore receives of data frames
--
2.26.2
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
