On Thu, 30 Apr 2020 17:34:11 +0800, Xin Ji wrote:
> The ANX7625 is an ultra-low power 4K Mobile HD Transmitter designed
> for portable device. It converts MIPI to DisplayPort 1.3 4K.
>
> You can add support to your board with binding.
>
> Example:
> anx7625_bridge: encoder@58 {
> compatible = "analogix,anx7625";
> reg = <0x58>;
> status = "okay";
> enable-gpios = <&pio 45 GPIO_ACTIVE_HIGH>;
> reset-gpios = <&pio 73 GPIO_ACTIVE_HIGH>;
> #address-cells = <1>;
> #size-cells = <0>;
>
> ports {
> #address-cells = <1>;
> #size-cells = <0>;
>
> mipi2dp_bridge_in: port@0 {
> reg = <0>;
> anx7625_in: endpoint {
> remote-endpoint = <&mipi_dsi>;
> };
> };
>
> mipi2dp_bridge_out: port@1 {
> reg = <1>;
> anx7625_out: endpoint {
> remote-endpoint = <&panel_in>;
> };
> };
> };
> };
>
> Signed-off-by: Xin Ji <xji@xxxxxxxxxxxxxxxx>
> ---
> .../bindings/display/bridge/analogix,anx7625.yaml | 97 ++++++++++++++++++++++
> 1 file changed, 97 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/display/bridge/analogix,anx7625.yaml
>
My bot found errors running 'make dt_binding_check' on your patch:
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dts:21.13-26: Warning (reg_format): /example-0/encoder@58:reg: property has invalid length (4 bytes) (#address-cells == 1, #size-cells == 1)
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dt.yaml: Warning (pci_device_reg): Failed prerequisite 'reg_format'
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dt.yaml: Warning (pci_device_bus_num): Failed prerequisite 'reg_format'
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dt.yaml: Warning (simple_bus_reg): Failed prerequisite 'reg_format'
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dt.yaml: Warning (i2c_bus_reg): Failed prerequisite 'reg_format'
Documentation/devicetree/bindings/display/bridge/analogix,anx7625.example.dt.yaml: Warning (spi_bus_reg): Failed prerequisite 'reg_format'
See https://patchwork.ozlabs.org/patch/1280084
If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure dt-schema is up to date:
pip3 install git+https://github.com/devicetree-org/dt-schema.git@master --upgrade
Please check and re-submit.
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
