On Fri, 11 Oct 2019, Gabriela Bittencourt wrote:
> Cleans up checks of "Alignment should match open parenthesis" in tree sm750fb
>
> Signed-off-by: Gabriela Bittencourt <gabrielabittencourt00@xxxxxxxxx>
> ---
> drivers/staging/sm750fb/ddk750_display.c | 2 +-
> drivers/staging/sm750fb/sm750_accel.c | 2 +-
> drivers/staging/sm750fb/sm750_accel.h | 8 ++++----
> drivers/staging/sm750fb/sm750_cursor.h | 10 +++++-----
> 4 files changed, 11 insertions(+), 11 deletions(-)
>
> diff --git a/drivers/staging/sm750fb/ddk750_display.c b/drivers/staging/sm750fb/ddk750_display.c
> index 887ea8aef43f..8be98a1058d6 100644
> --- a/drivers/staging/sm750fb/ddk750_display.c
> +++ b/drivers/staging/sm750fb/ddk750_display.c
> @@ -148,7 +148,7 @@ void ddk750_set_logical_disp_out(enum disp_output output)
> if (output & PNL_SEQ_USAGE) {
> /* set panel sequence */
> sw_panel_power_sequence((output & PNL_SEQ_MASK) >> PNL_SEQ_OFFSET,
> - 4);
> + 4);
> }
>
> if (output & DAC_USAGE)
> diff --git a/drivers/staging/sm750fb/sm750_accel.c b/drivers/staging/sm750fb/sm750_accel.c
> index dbcbbd1055da..1a9555bb9edd 100644
> --- a/drivers/staging/sm750fb/sm750_accel.c
> +++ b/drivers/staging/sm750fb/sm750_accel.c
> @@ -289,7 +289,7 @@ static unsigned int deGetTransparency(struct lynx_accel *accel)
> }
>
> int sm750_hw_imageblit(struct lynx_accel *accel,
> - const char *pSrcbuf, /* pointer to start of source buffer in system memory */
> + const char *pSrcbuf, /* pointer to start of source buffer in system memory */
> u32 srcDelta, /* Pitch value (in bytes) of the source buffer, +ive means top down and -ive mean button up */
> u32 startBit, /* Mono data can start at any bit in a byte, this value should be 0 to 7 */
> u32 dBase, /* Address of destination: offset in frame buffer */
It is strange that the change is only does for the firsr parameter, and
not for all of them.
The kernel also uses a doc format for describing function patameters in a
single comment before the function. Look around in other files to see the
format. That would look much nicer than these comments going over 80
columns.
> diff --git a/drivers/staging/sm750fb/sm750_accel.h b/drivers/staging/sm750fb/sm750_accel.h
> index c4f42002a50f..8fb79b09fdd0 100644
> --- a/drivers/staging/sm750fb/sm750_accel.h
> +++ b/drivers/staging/sm750fb/sm750_accel.h
> @@ -190,9 +190,9 @@ void sm750_hw_set2dformat(struct lynx_accel *accel, int fmt);
> void sm750_hw_de_init(struct lynx_accel *accel);
>
> int sm750_hw_fillrect(struct lynx_accel *accel,
> - u32 base, u32 pitch, u32 Bpp,
> - u32 x, u32 y, u32 width, u32 height,
> - u32 color, u32 rop);
> + u32 base, u32 pitch, u32 Bpp,
> + u32 x, u32 y, u32 width, u32 height,
> + u32 color, u32 rop);
>
> int sm750_hw_copyarea(
> struct lynx_accel *accel,
> @@ -210,7 +210,7 @@ unsigned int height, /* width and height of rectangle in pixel value */
> unsigned int rop2);
>
> int sm750_hw_imageblit(struct lynx_accel *accel,
> - const char *pSrcbuf, /* pointer to start of source buffer in system memory */
> + const char *pSrcbuf, /* pointer to start of source buffer in system memory */
> u32 srcDelta, /* Pitch value (in bytes) of the source buffer, +ive means top down and -ive mean button up */
> u32 startBit, /* Mono data can start at any bit in a byte, this value should be 0 to 7 */
> u32 dBase, /* Address of destination: offset in frame buffer */
Same here.
> diff --git a/drivers/staging/sm750fb/sm750_cursor.h b/drivers/staging/sm750fb/sm750_cursor.h
> index 16ac07eb58d6..039ebfdf0bd9 100644
> --- a/drivers/staging/sm750fb/sm750_cursor.h
> +++ b/drivers/staging/sm750fb/sm750_cursor.h
> @@ -6,13 +6,13 @@
> void sm750_hw_cursor_enable(struct lynx_cursor *cursor);
> void sm750_hw_cursor_disable(struct lynx_cursor *cursor);
> void sm750_hw_cursor_setSize(struct lynx_cursor *cursor,
> - int w, int h);
> + int w, int h);
> void sm750_hw_cursor_setPos(struct lynx_cursor *cursor,
> - int x, int y);
> + int x, int y);
Perhaps these could just be all on one line?
julia
> void sm750_hw_cursor_setColor(struct lynx_cursor *cursor,
> - u32 fg, u32 bg);
> + u32 fg, u32 bg);
> void sm750_hw_cursor_setData(struct lynx_cursor *cursor,
> - u16 rop, const u8 *data, const u8 *mask);
> + u16 rop, const u8 *data, const u8 *mask);
> void sm750_hw_cursor_setData2(struct lynx_cursor *cursor,
> - u16 rop, const u8 *data, const u8 *mask);
> + u16 rop, const u8 *data, const u8 *mask);
> #endif
> --
> 2.20.1
>
> --
> You received this message because you are subscribed to the Google Groups "outreachy-kernel" group.
> To unsubscribe from this group and stop receiving emails from it, send an email to outreachy-kernel+unsubscribe@xxxxxxxxxxxxxxxx.
> To view this discussion on the web visit https://groups.google.com/d/msgid/outreachy-kernel/20191012011956.9452-1-gabrielabittencourt00%40gmail.com.
>
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
