Hi Greg,
On Fri, Jun 21, 2019 at 2:35 PM Greg Ungerer <gerg@xxxxxxxxxx> wrote:
>
> Hi Sergio,
>
> On 21/6/19 4:15 pm, Sergio Paracuellos wrote:
> > This patch series properly handle minor issues in this driver. These are:
> > * Disable pcie port clock on pci dirver instead of doing it in the phy
> > driver. The pci driver is the correct place to do this.
> > * Add a missing call to phy_exit function to properly handle the function
> > 'mt7621_pcie_init_port' error path.
> > * Move driver to init in a later stage using 'module_init' instead of using
> > 'arch_initcall'.
> >
> > Patches are only compile-tested. It would be awasome to be tested before applied
> > them (mainly the change to 'module_init' stuff).
>
> Quick test - not though or extensive.
> On 3 boots it successfully booted for me twice with:
>
> rt2880-pinmux pinctrl: pcie is already enabled
> mt7621-pci 1e140000.pcie: Error applying setting, reverse things back
> mt7621-pci-phy 1e149000.pcie-phy: Xtal is 40MHz
> mt7621-pci 1e140000.pcie: Port 0 N_FTS = 1b102800
> mt7621-pci-phy 1e149000.pcie-phy: Xtal is 40MHz
> mt7621-pci 1e140000.pcie: Port 1 N_FTS = 1b102800
> mt7621-pci-phy 1e14a000.pcie-phy: Xtal is 40MHz
> mt7621-pci 1e140000.pcie: Port 2 N_FTS = 1b102800
> mt7621-pci 1e140000.pcie: pcie1 no card, disable it (RST & CLK)
> mt7621-pci 1e140000.pcie: pcie2 no card, disable it (RST & CLK)
> mt7621-pci 1e140000.pcie: PCIE0 enabled
> mt7621-pci 1e140000.pcie: PCI coherence region base: 0x60000000, mask/settings: 0xf0000002
> mt7621-pci 1e140000.pcie: PCI host bridge to bus 0000:00
> pci_bus 0000:00: root bus resource [io 0xffffffff]
> pci_bus 0000:00: root bus resource [mem 0x60000000-0x6fffffff]
> pci_bus 0000:00: root bus resource [bus 00-ff]
> pci 0000:00:00.0: [0e8d:0801] type 01 class 0x060400
> pci 0000:00:00.0: reg 0x10: [mem 0x00000000-0x7fffffff]
> pci 0000:00:00.0: reg 0x14: [mem 0x00000000-0x0000ffff]
> pci 0000:00:00.0: supports D1
> pci 0000:00:00.0: PME# supported from D0 D1 D3hot
> pci 0000:00:00.0: bridge configuration invalid ([bus 00-00]), reconfiguring
> pci 0000:01:00.0: [168c:003c] type 00 class 0x028000
> pci 0000:01:00.0: reg 0x10: [mem 0x00000000-0x001fffff 64bit]
> pci 0000:01:00.0: reg 0x30: [mem 0x00000000-0x0000ffff pref]
> pci 0000:01:00.0: supports D1 D2
> pci 0000:00:00.0: PCI bridge to [bus 01-ff]
> pci 0000:00:00.0: bridge window [io 0x0000-0x0fff]
> pci 0000:00:00.0: bridge window [mem 0x00000000-0x000fffff]
> pci 0000:00:00.0: bridge window [mem 0x00000000-0x000fffff pref]
> pci_bus 0000:01: busn_res: [bus 01-ff] end is updated to 01
> pci 0000:00:00.0: BAR 0: no space for [mem size 0x80000000]
> pci 0000:00:00.0: BAR 0: failed to assign [mem size 0x80000000]
> pci 0000:00:00.0: BAR 8: assigned [mem 0x60000000-0x601fffff]
> pci 0000:00:00.0: BAR 9: assigned [mem 0x60200000-0x602fffff pref]
> pci 0000:00:00.0: BAR 1: assigned [mem 0x60300000-0x6030ffff]
> pci 0000:00:00.0: BAR 7: no space for [io size 0x1000]
> pci 0000:00:00.0: BAR 7: failed to assign [io size 0x1000]
> pci 0000:01:00.0: BAR 0: assigned [mem 0x60000000-0x601fffff 64bit]
> pci 0000:01:00.0: BAR 6: assigned [mem 0x60200000-0x6020ffff pref]
> pci 0000:00:00.0: PCI bridge to [bus 01]
> pci 0000:00:00.0: bridge window [mem 0x60000000-0x601fffff]
> pci 0000:00:00.0: bridge window [mem 0x60200000-0x602fffff pref]
> pcieport 0000:00:00.0: of_irq_parse_pci: failed with rc=-22
> pcieport 0000:00:00.0: enabling device (0004 -> 0006)
>
> PCI devices worked ok on the 2 good boots.
Perfect, thanks for testing this.
>
> Regards
> Greg
Best regards,
Sergio Paracuellos
>
>
>
> > Hope this helps.
> >
> > Best regards,
> > Sergio Paracuellos
> >
> > Sergio Paracuellos (4):
> > staging: mt7621-pci: disable pcie port clock if there is no pcie link
> > staging: mt7621-pci: add phy exit call if phy_power_on call fails
> > staging: mt7621-pci-phy: remove disable clock from the phy exit
> > function
> > staging: mt7621-pci: use 'module_init' instead of 'arch_initcall'
> >
> > drivers/staging/mt7621-pci-phy/pci-mt7621-phy.c | 8 --------
> > drivers/staging/mt7621-pci/pci-mt7621.c | 10 +++++++++-
> > 2 files changed, 9 insertions(+), 9 deletions(-)
> >
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
