[PATCH RFC] staging: wilc1000: give usleep_range a range

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



usleep_range() is called in non-atomic context so there is little point
in setting min==max the jitter of hrtimer is determined by interruptions
anyway. usleep_range can only perform the intended coalescence if some
room for placing the hrtimer is provided. Given the range of milliseconds
the delay will be anything from 2 to a few anyway - so make it 2-5 ms.

Signed-off-by: Nicholas Mc Guire <hofrat@xxxxxxxxx>
---

Problem located with an experimental coccinelle script
./drivers/staging/wilc1000/wilc_wlan.c:411:4-16: WARNING: inefficient usleep_range with range 0 (min==max)
./drivers/staging/wilc1000/wilc_wlan.c:426:4-16: WARNING: inefficient usleep_range with range 0 (min==max)

Someone that knows the motivation for setting the time to 2 millisecond
might need to check if the 2 milliseconds where seen as tollerable max or
min - I'm assuming it was the min so extending.

Patch was compile tested with: x86_64_defconfig + Staging=y,
WILC1000_SDIO=m, WILC1000_SPI=m, WILC1000=m

Patch is against 5.1-rc3 (localversion-next is -next-20190405)

 drivers/staging/wilc1000/wilc_wlan.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/staging/wilc1000/wilc_wlan.c b/drivers/staging/wilc1000/wilc_wlan.c
index c238969..42da533 100644
--- a/drivers/staging/wilc1000/wilc_wlan.c
+++ b/drivers/staging/wilc1000/wilc_wlan.c
@@ -408,7 +408,7 @@ void chip_wakeup(struct wilc *wilc)
 			wilc->hif_func->hif_write_reg(wilc, 1, reg & ~BIT(1));
 
 			do {
-				usleep_range(2 * 1000, 2 * 1000);
+				usleep_range(2 * 1000, 5 * 1000);
 				wilc_get_chipid(wilc, true);
 			} while (wilc_get_chipid(wilc, true) == 0);
 		} while (wilc_get_chipid(wilc, true) == 0);
@@ -423,7 +423,7 @@ void chip_wakeup(struct wilc *wilc)
 						     &clk_status_reg);
 
 			while ((clk_status_reg & 0x1) == 0) {
-				usleep_range(2 * 1000, 2 * 1000);
+				usleep_range(2 * 1000, 5 * 1000);
 
 				wilc->hif_func->hif_read_reg(wilc, 0xf1,
 							     &clk_status_reg);
-- 
2.1.4

_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux