Moved code to configure sync to where check enable_sync option before. There is no need to check enable_sync twice. Configuring sync should be executed immediately after enabling sync. Signed-off-by: Sidong Yang <realwakka@xxxxxxxxx> --- v2: remove obvious comment. reordered size/value/enable sync functions. drivers/staging/pi433/pi433_if.c | 16 ++++++---------- 1 file changed, 6 insertions(+), 10 deletions(-) diff --git a/drivers/staging/pi433/pi433_if.c b/drivers/staging/pi433/pi433_if.c index 53928af696a6..8fa7b3346170 100644 --- a/drivers/staging/pi433/pi433_if.c +++ b/drivers/staging/pi433/pi433_if.c @@ -319,6 +319,12 @@ rf69_set_tx_cfg(struct pi433_device *dev, struct pi433_tx_cfg *tx_cfg) } if (tx_cfg->enable_sync == OPTION_ON) { + ret = rf69_set_sync_size(dev->spi, tx_cfg->sync_length); + if (ret < 0) + return ret; + ret = rf69_set_sync_values(dev->spi, tx_cfg->sync_pattern); + if (ret < 0) + return ret; ret = rf69_enable_sync(dev->spi); if (ret < 0) return ret; @@ -348,16 +354,6 @@ rf69_set_tx_cfg(struct pi433_device *dev, struct pi433_tx_cfg *tx_cfg) return ret; } - /* configure sync, if enabled */ - if (tx_cfg->enable_sync == OPTION_ON) { - ret = rf69_set_sync_size(dev->spi, tx_cfg->sync_length); - if (ret < 0) - return ret; - ret = rf69_set_sync_values(dev->spi, tx_cfg->sync_pattern); - if (ret < 0) - return ret; - } - return 0; } -- 2.17.1 _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel