The ad2s90 driver currently sets some spi settings (max_speed_hz and
mode) at ad2s90_probe. Since the maximum frequency is a required element
in DT binding for spi slave devices and because the spi mode for the
device can be either (0,0) or (1,1), these settings should be handled
via device tree, not in the driver's code. This patch removes them from
the probe function.
Note: The way in which the mentioned spi settings need to be specified
on the ad2s90's node of a device tree will be documented in the future
patch "dt-bindings:iio:resolver: Add docs for ad2s90".
Signed-off-by: Matheus Tavares <matheus.bernardino@xxxxxx>
---
Changes in v2:
- Rewritten patch message to better explain why the code snippet in
question should be removed.
drivers/staging/iio/resolver/ad2s90.c | 11 -----------
1 file changed, 11 deletions(-)
diff --git a/drivers/staging/iio/resolver/ad2s90.c b/drivers/staging/iio/resolver/ad2s90.c
index 6ffbac66b837..913d6fad2d4d 100644
--- a/drivers/staging/iio/resolver/ad2s90.c
+++ b/drivers/staging/iio/resolver/ad2s90.c
@@ -77,7 +77,6 @@ static int ad2s90_probe(struct spi_device *spi)
{
struct iio_dev *indio_dev;
struct ad2s90_state *st;
- int ret;
indio_dev = devm_iio_device_alloc(&spi->dev, sizeof(*st));
if (!indio_dev)
@@ -94,16 +93,6 @@ static int ad2s90_probe(struct spi_device *spi)
indio_dev->num_channels = 1;
indio_dev->name = spi_get_device_id(spi)->name;
- /* need 600ns between CS and the first falling edge of SCLK */
- spi->max_speed_hz = 830000;
- spi->mode = SPI_MODE_3;
- ret = spi_setup(spi);
-
- if (ret < 0) {
- dev_err(&spi->dev, "spi_setup failed!\n");
- return ret;
- }
-
return devm_iio_device_register(indio_dev->dev.parent, indio_dev);
}
--
2.18.0
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
