On Fri, 9 Nov 2018 20:00:42 -0200 Matheus Tavares <matheus.bernardino@xxxxxx> wrote: > This patch adds the device tree binding documentation for the ad2s90 > resolver-to-digital converter. > > Signed-off-by: Matheus Tavares <matheus.bernardino@xxxxxx> > --- > .../bindings/iio/resolver/ad2s90.txt | 26 +++++++++++++++++++ > 1 file changed, 26 insertions(+) > create mode 100644 Documentation/devicetree/bindings/iio/resolver/ad2s90.txt > > diff --git a/Documentation/devicetree/bindings/iio/resolver/ad2s90.txt b/Documentation/devicetree/bindings/iio/resolver/ad2s90.txt > new file mode 100644 > index 000000000000..b42cc7752ffd > --- /dev/null > +++ b/Documentation/devicetree/bindings/iio/resolver/ad2s90.txt > @@ -0,0 +1,26 @@ > +Analog Devices AD2S90 Resolver-to-Digital Converter > + > +https://www.analog.com/en/products/ad2s90.html > + > +Required properties: > + - compatible : should be "adi,ad2s90" > + - reg : SPI chip select number for the device > + - spi-max-frequency : set maximum clock frequency, must be 830000 > + - spi-cpol and spi-cpha : must be defined to enable SPI mode 3 As the part only works in mode 3, my gut feeling is that this belongs in the driver, not here. Rob, what do you think? > + > +Note about max frequency: > + Chip's max frequency, as specified in its datasheet, is 2Mhz. But a 600ns > + delay is expected between the application of a logic LO to CS and the > + application of SCLK, as also specified. And since the delay is not > + implemented in the spi code, to satisfy it, SCLK's period should be at most > + 2 * 600ns, so the max frequency should be 1 / (2 * 6e-7), which gives > + roughly 830000Hz. > + > +Example: > +resolver@0 { > + compatible = "adi,ad2s90"; > + reg = <0>; > + spi-max-frequency = <830000>; > + spi-cpol; > + spi-cpha; > +}; _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel