From: Todd Poynor <toddpoynor@xxxxxxxxxx>
Drop gasket logging calls in favor of standard logging.
Signed-off-by: Todd Poynor <toddpoynor@xxxxxxxxxx>
---
drivers/staging/gasket/apex_driver.c | 61 ++++++++++++----------------
1 file changed, 26 insertions(+), 35 deletions(-)
diff --git a/drivers/staging/gasket/apex_driver.c b/drivers/staging/gasket/apex_driver.c
index 6396b18b246a5..73fc2683a834d 100644
--- a/drivers/staging/gasket/apex_driver.c
+++ b/drivers/staging/gasket/apex_driver.c
@@ -7,11 +7,13 @@
#include <linux/compiler.h>
#include <linux/delay.h>
+#include <linux/device.h>
#include <linux/fs.h>
#include <linux/init.h>
#include <linux/mm.h>
#include <linux/module.h>
#include <linux/moduleparam.h>
+#include <linux/printk.h>
#include <linux/sched.h>
#include <linux/uaccess.h>
@@ -19,7 +21,6 @@
#include "gasket_core.h"
#include "gasket_interrupt.h"
-#include "gasket_logging.h"
#include "gasket_page_table.h"
#include "gasket_sysfs.h"
@@ -362,11 +363,9 @@ static int apex_add_dev_cb(struct gasket_dev *gasket_dev)
if (retries == APEX_RESET_RETRY) {
if (!page_table_ready)
- gasket_log_error(
- gasket_dev, "Page table init timed out.");
+ dev_err(gasket_dev->dev, "Page table init timed out\n");
if (!msix_table_ready)
- gasket_log_error(
- gasket_dev, "MSI-X table init timed out.");
+ dev_err(gasket_dev->dev, "MSI-X table init timed out\n");
return -ETIMEDOUT;
}
@@ -420,12 +419,9 @@ static int apex_device_cleanup(struct gasket_dev *gasket_dev)
gasket_dev, APEX_BAR_INDEX,
APEX_BAR2_REG_SCALAR_CORE_ERROR_STATUS);
- gasket_log_debug(
- gasket_dev,
- "%s 0x%p hib_error 0x%llx scalar_error "
- "0x%llx.",
- __func__,
- gasket_dev, hib_error, scalar_error);
+ dev_dbg(gasket_dev->dev,
+ "%s 0x%p hib_error 0x%llx scalar_error 0x%llx\n",
+ __func__, gasket_dev, hib_error, scalar_error);
if (allow_power_save)
ret = apex_enter_reset(gasket_dev, APEX_CHIP_REINIT_RESET);
@@ -452,7 +448,7 @@ static int apex_reset(struct gasket_dev *gasket_dev, uint type)
/* We are not in reset - toggle the reset bit so as to force
* re-init of custom block
*/
- gasket_log_debug(gasket_dev, "%s: toggle reset.", __func__);
+ dev_dbg(gasket_dev->dev, "%s: toggle reset\n", __func__);
ret = apex_enter_reset(gasket_dev, type);
if (ret)
@@ -489,9 +485,9 @@ static int apex_enter_reset(struct gasket_dev *gasket_dev, uint type)
if (gasket_wait_with_reschedule(gasket_dev, APEX_BAR_INDEX,
APEX_BAR2_REG_USER_HIB_DMA_PAUSED, 1, 1,
APEX_RESET_DELAY, APEX_RESET_RETRY)) {
- gasket_log_error(gasket_dev,
- "DMAs did not quiesce within timeout (%d ms)",
- APEX_RESET_RETRY * APEX_RESET_DELAY);
+ dev_err(gasket_dev->dev,
+ "DMAs did not quiesce within timeout (%d ms)\n",
+ APEX_RESET_RETRY * APEX_RESET_DELAY);
return -ETIMEDOUT;
}
@@ -511,9 +507,8 @@ static int apex_enter_reset(struct gasket_dev *gasket_dev, uint type)
if (gasket_wait_with_reschedule(gasket_dev, APEX_BAR_INDEX,
APEX_BAR2_REG_SCU_3, 1 << 6, 1 << 6,
APEX_RESET_DELAY, APEX_RESET_RETRY)) {
- gasket_log_error(
- gasket_dev,
- "RAM did not shut down within timeout (%d ms)",
+ dev_err(gasket_dev->dev,
+ "RAM did not shut down within timeout (%d ms)\n",
APEX_RESET_RETRY * APEX_RESET_DELAY);
return -ETIMEDOUT;
}
@@ -560,9 +555,8 @@ static int apex_quit_reset(struct gasket_dev *gasket_dev, uint type)
if (gasket_wait_with_reschedule(gasket_dev, APEX_BAR_INDEX,
APEX_BAR2_REG_SCU_3, 1 << 6, 0,
APEX_RESET_DELAY, APEX_RESET_RETRY)) {
- gasket_log_error(
- gasket_dev,
- "RAM did not enable within timeout (%d ms)",
+ dev_err(gasket_dev->dev,
+ "RAM did not enable within timeout (%d ms)\n",
APEX_RESET_RETRY * APEX_RESET_DELAY);
return -ETIMEDOUT;
}
@@ -572,9 +566,8 @@ static int apex_quit_reset(struct gasket_dev *gasket_dev, uint type)
APEX_BAR2_REG_SCU_3,
SCU3_CUR_RST_GCB_BIT_MASK, 0,
APEX_RESET_DELAY, APEX_RESET_RETRY)) {
- gasket_log_error(
- gasket_dev,
- "GCB did not leave reset within timeout (%d ms)",
+ dev_err(gasket_dev->dev,
+ "GCB did not leave reset within timeout (%d ms)\n",
APEX_RESET_RETRY * APEX_RESET_DELAY);
return -ETIMEDOUT;
}
@@ -589,9 +582,8 @@ static int apex_quit_reset(struct gasket_dev *gasket_dev, uint type)
SCU3_RG_PWR_STATE_OVR_BIT_OFFSET);
val1 = gasket_dev_read_32(
gasket_dev, APEX_BAR_INDEX, APEX_BAR2_REG_SCU_3);
- gasket_log_debug(
- gasket_dev, "Disallow HW clock gating 0x%x -> 0x%x",
- val0, val1);
+ dev_dbg(gasket_dev->dev,
+ "Disallow HW clock gating 0x%x -> 0x%x\n", val0, val1);
} else {
val0 = gasket_dev_read_32(
gasket_dev, APEX_BAR_INDEX, APEX_BAR2_REG_SCU_3);
@@ -602,9 +594,8 @@ static int apex_quit_reset(struct gasket_dev *gasket_dev, uint type)
SCU3_RG_PWR_STATE_OVR_BIT_OFFSET);
val1 = gasket_dev_read_32(
gasket_dev, APEX_BAR_INDEX, APEX_BAR2_REG_SCU_3);
- gasket_log_debug(
- gasket_dev, "Allow HW clock gating 0x%x -> 0x%x", val0,
- val1);
+ dev_dbg(gasket_dev->dev, "Allow HW clock gating 0x%x -> 0x%x\n",
+ val0, val1);
}
return 0;
@@ -668,7 +659,7 @@ static long apex_clock_gating(struct gasket_dev *gasket_dev,
if (copy_from_user(&ibuf, argp, sizeof(ibuf)))
return -EFAULT;
- gasket_log_debug(gasket_dev, "%s %llu", __func__, ibuf.enable);
+ dev_dbg(gasket_dev->dev, "%s %llu\n", __func__, ibuf.enable);
if (ibuf.enable) {
/* Quiesce AXI, gate GCB clock. */
@@ -709,13 +700,13 @@ static ssize_t sysfs_show(
gasket_dev = gasket_sysfs_get_device_data(device);
if (!gasket_dev) {
- gasket_nodev_error("No Apex device sysfs mapping found");
+ dev_err(device, "No Apex device sysfs mapping found\n");
return -ENODEV;
}
gasket_attr = gasket_sysfs_get_attr(device, attr);
if (!gasket_attr) {
- gasket_nodev_error("No Apex device sysfs attr data found");
+ dev_err(device, "No Apex device sysfs attr data found\n");
gasket_sysfs_put_device_data(device, gasket_dev);
return -ENODEV;
}
@@ -738,8 +729,8 @@ static ssize_t sysfs_show(
gasket_dev->page_table[0]));
break;
default:
- gasket_log_debug(
- gasket_dev, "Unknown attribute: %s", attr->attr.name);
+ dev_dbg(gasket_dev->dev, "Unknown attribute: %s\n",
+ attr->attr.name);
ret = 0;
break;
}
--
2.18.0.345.g5c9ce644c3-goog
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
