There are some comments not needed at all. Remove them.
Adjust one comment to follow kernel style.
Signed-off-by: Sergio Paracuellos <sergio.paracuellos@xxxxxxxxx>
---
drivers/staging/mt7621-pci/pci-mt7621.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/drivers/staging/mt7621-pci/pci-mt7621.c b/drivers/staging/mt7621-pci/pci-mt7621.c
index 6286762..87c8df4 100644
--- a/drivers/staging/mt7621-pci/pci-mt7621.c
+++ b/drivers/staging/mt7621-pci/pci-mt7621.c
@@ -130,7 +130,6 @@ static struct pcie_controller_data pcie_controllers[] = {
#define RALINK_PCIE_CLK_GEN 0x7c
#define RALINK_PCIE_CLK_GEN1 0x80
-//RALINK_RSTCTRL bit
#define RALINK_PCIE_RST BIT(23)
#define MEMORY_BASE 0x0
@@ -282,8 +281,8 @@ pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
printk("BAR0 at slot %d = %x\n", slot, val);
}
- pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 0x14); //configure cache line size 0x14
- pci_write_config_byte(dev, PCI_LATENCY_TIMER, 0xFF); //configure latency timer 0x10
+ pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 0x14);
+ pci_write_config_byte(dev, PCI_LATENCY_TIMER, 0xFF);
pci_read_config_word(dev, PCI_COMMAND, &cmd);
cmd = cmd | PCI_COMMAND_MASTER | PCI_COMMAND_IO | PCI_COMMAND_MEMORY;
pci_write_config_word(dev, PCI_COMMAND, cmd);
@@ -404,9 +403,11 @@ void setup_cm_memory_region(struct resource *mem_resource)
resource_size_t mask;
if (mips_cps_numiocu(0)) {
- /* FIXME: hardware doesn't accept mask values with 1s after
+ /*
+ * FIXME: hardware doesn't accept mask values with 1s after
* 0s (e.g. 0xffef), so it would be great to warn if that's
- * about to happen */
+ * about to happen
+ */
mask = ~(mem_resource->end - mem_resource->start);
write_gcr_reg1_base(mem_resource->start);
--
2.7.4
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
