On Mon, Apr 16, 2018 at 6:54 AM, Jun Li <jun.li@xxxxxxx> wrote: > Hi >> -----Original Message----- >> From: Rob Herring [mailto:robh@xxxxxxxxxx] >> Sent: 2018年4月10日 4:04 >> To: Jun Li <jun.li@xxxxxxx> >> Cc: gregkh@xxxxxxxxxxxxxxxxxxx; heikki.krogerus@xxxxxxxxxxxxxxx; >> linux@xxxxxxxxxxxx; a.hajda@xxxxxxxxxxx; shufan_lee@xxxxxxxxxxx; Peter >> Chen <peter.chen@xxxxxxx>; devicetree@xxxxxxxxxxxxxxx; >> linux-usb@xxxxxxxxxxxxxxx; dl-linux-imx <linux-imx@xxxxxxx>; >> devel@xxxxxxxxxxxxxxxxxxxx >> Subject: Re: [PATCH v4 02/13] dt-bindings: usb: add documentation for typec >> port controller(TCPCI) >> >> On Thu, Mar 29, 2018 at 12:06:07AM +0800, Li Jun wrote: [...] >> > +ptn5110@50 { >> > + compatible = "usb-tcpci,ptn5110"; >> > + reg = <0x50>; >> > + interrupt-parent = <&gpio3>; >> > + interrupts = <3 IRQ_TYPE_LEVEL_LOW>; >> > + >> > + usb_con: connector { >> >> How is the OF graph done in this case? You need some link to the USB controller. > > The platform(i.MX8MQ EVK) for this is still on the way of start upstream, I was > Planning to add this part with enabling USB3 function, as of how this will be done, > I only have usb3 ss data(no display port or Sideband), is something like below OK? > > typec: ptn5110@50 { > compatible = "nxp,ptn5110"; > ... > > usb_con: connector { > compatible = "usb-c-connector"; > label = "USB-C"; > ... > > ports { > #address-cells = <1>; > #size-cells = <0>; > > port@1 { > reg = <1>; > usb_con_ss: endpoint { > remote-endpoint = <&usb3_phy_ss>; > }; > }; > }; > }; > }; > > &usb3_phy0 { > status = "okay"; > > port { > usb3_phy_ss: endpoint { Normally, the graph connection would be to the USB controller, not the phy as the phy is just referred to with a "phys" property. > remote-endpoint = <&usb_con_ss>; > }; > }; > } _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
