On Fri, 30 Jun 2017 11:21:14 -0400
Brian Masney <masneyb@xxxxxxxxxxxxx> wrote:
> On Thu, Jun 29, 2017 at 01:03:46PM -0400, Brian Masney wrote:
> > This begins my work to clean this driver up and eventually move it out
> > of staging. Driver changes were tested using a TSL2771 hooked up to a
> > Raspberry Pi 2.
> >
> > Thanks to Jon Brenner at AMS/TAOS for loaning me some hardware samples
> > to test my driver changes.
> >
> > Brian Masney (6):
> > staging: iio: tsl2x7x: add of_match table for device tree support
> > staging: iio: tsl2x7x: remove redundant power_state sysfs attribute
> > staging: iio: tsl2x7x: remove tsl2x7x_i2c_read()
> > staging: iio: tsl2x7x: cleaned up i2c calls in tsl2x7x_als_calibrate()
> > staging: iio: tsl2x7x: refactor {read,write}_event_value to allow
> > handling multiple iio_event_infos
> > staging: iio: tsl2x7x: use usleep_range() instead of mdelay()
> >
> > .../devicetree/bindings/trivial-devices.txt | 10 +
> > drivers/staging/iio/light/tsl2x7x.c | 316 ++++++++++-----------
> > 2 files changed, 153 insertions(+), 173 deletions(-)
>
> Hi Jonathon,
>
> Hold off on applying this series.
Will do.
> There are several other formatting
> warnings from checkpatch with this series that I need to fix. Sorry
> about the noise. I'd appreciate it if you could at least look at the
> functionality of my changes and I'll resubmit next week.
All fine except possibly needing a stronger justification for patch 5.
I'm not against the patch - and it may be fine on the basis that
it lines up better with the standard form in other drivers, but
right now there isn't anything actually 'wrong' with the existing code.
J
>
> I held back several other changes related to the event subsystem until
> I'm able to properly test my changes. I'm having trouble getting the
> interrupts to work. I wired the interrupt pin on the sensor to GPIO
> pin 17 on my Raspberry Pi 2 and added the following section to
> arch/arm/boot/dts/bcm2836-rpi-2-b.dts for my sensor:
>
> &i2c1 {
> tsl2771@29 {
> compatible = "amstaos,tsl2771";
> reg = <0x39>;
> interrupt-parent = <&gpio>;
> interrupts = <17 2>;
> };
> };
>
> I start up iio_event_monitor, and run these commands:
>
> echo 1 > events/in_intensity0_thresh_rising_en
> echo 256 > events/in_intensity0_thresh_rising_value
>
> When I shine a light on the ALS sensor, and the reading goes above
> 256, I do not get any events back from iio_event_monitor.
>
> I'm honestly not sure about the 2 in the 'interrupts = <17 2>;' line.
> I looked at how interrupts were setup in device tree overlays in the
> official Raspberry Pi kernel and tried several variations from there.
> I have more reading to do. :)
>
> Thanks,
>
> Brian
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
