From: Lars Lindley <lindley@xxxxxxxxxx>
I fixed all problems reported by checkpatch.pl except for a couple of
long lines. I also removed version comments and removed "commented away"
code.
Signed-off-by: Lars Lindley <lindley@xxxxxxxxxx>
Acked-by: Pavel Machek <pavel@xxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxx>
---
drivers/staging/winbond/mto.h | 179 +++++++++++++++++++----------------------
1 files changed, 82 insertions(+), 97 deletions(-)
diff --git a/drivers/staging/winbond/mto.h b/drivers/staging/winbond/mto.h
index fb4781d..a0f659c 100644
--- a/drivers/staging/winbond/mto.h
+++ b/drivers/staging/winbond/mto.h
@@ -1,13 +1,10 @@
-//==================================================================
-// MTO.H
-//
-// Revision history
-//=================================
-// 20030110 UN20 Pete Chao
-// Initial Release
-//
-// Copyright (c) 2003 Winbond Electronics Corp. All rights reserved.
-//==================================================================
+/*
+ * ==================================================================
+ * MTO.H
+ *
+ * Copyright (c) 2003 Winbond Electronics Corp. All rights reserved.
+ * ==================================================================
+ */
#ifndef __MTO_H__
#define __MTO_H__
@@ -15,115 +12,104 @@
struct wbsoft_priv;
-// LA20040210_DTO kevin
-//#define MTO_PREAMBLE_LONG 0
-//#define MTO_PREAMBLE_SHORT 1
#define MTO_PREAMBLE_LONG WLAN_PREAMBLE_TYPE_LONG
#define MTO_PREAMBLE_SHORT WLAN_PREAMBLE_TYPE_SHORT
-//============================================================================
-// struct _MTOParameters --
-//
-// Defines the parameters used in the MAC Throughput Optimization algorithm
-//============================================================================
+/* Defines the parameters used in the MAC Throughput Optimization algorithm */
struct wb35_mto_params {
- //--------- wkchen added -------------
- u32 TxFlowCount; //to judge what kind the tx flow(sparse or busy) is
- //------------------------------------------------
+ u32 TxFlowCount; /* to judge what kind the tx flow(sparse or busy) is */
- //--------- DTO threshold parameters -------------
- u16 DTO_PeriodicCheckCycle;
- u16 DTO_RssiThForAntDiv;
+ /* --------- DTO threshold parameters ------------- */
+ u16 DTO_PeriodicCheckCycle;
+ u16 DTO_RssiThForAntDiv;
- u16 DTO_TxCountThForCalcNewRate;
- u16 DTO_TxRateIncTh;
+ u16 DTO_TxCountThForCalcNewRate;
+ u16 DTO_TxRateIncTh;
- u16 DTO_TxRateDecTh;
- u16 DTO_TxRateEqTh;
+ u16 DTO_TxRateDecTh;
+ u16 DTO_TxRateEqTh;
- u16 DTO_TxRateBackOff;
- u16 DTO_TxRetryRateReduce;
+ u16 DTO_TxRateBackOff;
+ u16 DTO_TxRetryRateReduce;
- u16 DTO_TxPowerIndex; //0 ~ 31
- u16 reserved_1;
- //------------------------------------------------
+ u16 DTO_TxPowerIndex; /* 0 ~ 31 */
+ u16 reserved_1;
+ /* ------------------------------------------------ */
- u8 PowerChangeEnable;
- u8 AntDiversityEnable;
- u8 CCA_Mode;
- u8 CCA_Mode_Setup;
- u8 Preamble_Type;
- u8 PreambleChangeEnable;
+ u8 PowerChangeEnable;
+ u8 AntDiversityEnable;
+ u8 CCA_Mode;
+ u8 CCA_Mode_Setup;
+ u8 Preamble_Type;
+ u8 PreambleChangeEnable;
- u8 DataRateLevel;
- u8 DataRateChangeEnable;
- u8 FragThresholdLevel;
- u8 FragThresholdChangeEnable;
+ u8 DataRateLevel;
+ u8 DataRateChangeEnable;
+ u8 FragThresholdLevel;
+ u8 FragThresholdChangeEnable;
- u16 RTSThreshold;
- u16 RTSThreshold_Setup;
+ u16 RTSThreshold;
+ u16 RTSThreshold_Setup;
- u32 AvgIdleSlot;
- u32 Pr_Interf;
- u32 AvgGapBtwnInterf;
+ u32 AvgIdleSlot;
+ u32 Pr_Interf;
+ u32 AvgGapBtwnInterf;
- u8 RTSChangeEnable;
- u8 Ant_sel;
- u8 aging_timeout;
- u8 reserved_2;
+ u8 RTSChangeEnable;
+ u8 Ant_sel;
+ u8 aging_timeout;
+ u8 reserved_2;
- u32 Cnt_Ant[2];
- u32 SQ_Ant[2];
+ u32 Cnt_Ant[2];
+ u32 SQ_Ant[2];
-// 20040510 remove from globe vairable
- u8 FallbackRateLevel;
- u8 OfdmRateLevel;
+ u8 FallbackRateLevel;
+ u8 OfdmRateLevel;
- u8 RatePolicy;
- u8 reserved_3[3];
-
- // For RSSI turning
- s32 RSSI_high;
- s32 RSSI_low;
+ u8 RatePolicy;
+ u8 reserved_3[3];
+ /* For RSSI turning */
+ s32 RSSI_high;
+ s32 RSSI_low;
};
-#define MTO_DATA() (adapter->sMtoPara)
-#define MTO_HAL() (&adapter->sHwData)
-#define MTO_SET_PREAMBLE_TYPE(x) // 20040511 Turbo mark LM_PREAMBLE_TYPE(&pcore_data->lm_data) = (x)
-#define MTO_ENABLE (adapter->sLocalPara.TxRateMode == RATE_AUTO)
-#define MTO_TXPOWER_FROM_EEPROM (adapter->sHwData.PowerIndexFromEEPROM)
-#define LOCAL_ANTENNA_NO() (adapter->sLocalPara.bAntennaNo)
-#define LOCAL_IS_CONNECTED() (adapter->sLocalPara.wConnectedSTAindex != 0)
-#define MTO_INITTXRATE_MODE (adapter->sHwData.SoftwareSet&0x2) //bit 1
+#define MTO_DATA() (adapter->sMtoPara)
+#define MTO_HAL() (&adapter->sHwData)
+#define MTO_SET_PREAMBLE_TYPE(x) /* Turbo mark LM_PREAMBLE_TYPE(&pcore_data->lm_data) = (x) */
+#define MTO_ENABLE (adapter->sLocalPara.TxRateMode == RATE_AUTO)
+#define MTO_TXPOWER_FROM_EEPROM (adapter->sHwData.PowerIndexFromEEPROM)
+#define LOCAL_ANTENNA_NO() (adapter->sLocalPara.bAntennaNo)
+#define LOCAL_IS_CONNECTED() (adapter->sLocalPara.wConnectedSTAindex != 0)
+#define MTO_INITTXRATE_MODE (adapter->sHwData.SoftwareSet&0x2) /* bit 1 */
-#define MTO_POWER_CHANGE_ENABLE() MTO_DATA().PowerChangeEnable
-#define MTO_CCA_MODE() MTO_DATA().CCA_Mode
-#define MTO_CCA_MODE_SETUP() MTO_DATA().CCA_Mode_Setup
-#define MTO_PREAMBLE_TYPE() MTO_DATA().Preamble_Type
-#define MTO_PREAMBLE_CHANGE_ENABLE() MTO_DATA().PreambleChangeEnable
+#define MTO_POWER_CHANGE_ENABLE() MTO_DATA().PowerChangeEnable
+#define MTO_CCA_MODE() MTO_DATA().CCA_Mode
+#define MTO_CCA_MODE_SETUP() MTO_DATA().CCA_Mode_Setup
+#define MTO_PREAMBLE_TYPE() MTO_DATA().Preamble_Type
+#define MTO_PREAMBLE_CHANGE_ENABLE() MTO_DATA().PreambleChangeEnable
-#define MTO_RATE_LEVEL() MTO_DATA().DataRateLevel
+#define MTO_RATE_LEVEL() MTO_DATA().DataRateLevel
#define MTO_OFDM_RATE_LEVEL() MTO_DATA().OfdmRateLevel
-#define MTO_RATE_CHANGE_ENABLE() MTO_DATA().DataRateChangeEnable
-#define MTO_FRAG_TH_LEVEL() MTO_DATA().FragThresholdLevel
-#define MTO_FRAG_CHANGE_ENABLE() MTO_DATA().FragThresholdChangeEnable
-#define MTO_RTS_THRESHOLD() MTO_DATA().RTSThreshold
-#define MTO_RTS_CHANGE_ENABLE() MTO_DATA().RTSChangeEnable
-#define MTO_RTS_THRESHOLD_SETUP() MTO_DATA().RTSThreshold_Setup
+#define MTO_RATE_CHANGE_ENABLE() MTO_DATA().DataRateChangeEnable
+#define MTO_FRAG_TH_LEVEL() MTO_DATA().FragThresholdLevel
+#define MTO_FRAG_CHANGE_ENABLE() MTO_DATA().FragThresholdChangeEnable
+#define MTO_RTS_THRESHOLD() MTO_DATA().RTSThreshold
+#define MTO_RTS_CHANGE_ENABLE() MTO_DATA().RTSChangeEnable
+#define MTO_RTS_THRESHOLD_SETUP() MTO_DATA().RTSThreshold_Setup
-#define MTO_AVG_IDLE_SLOT() MTO_DATA().AvgIdleSlot
-#define MTO_PR_INTERF() MTO_DATA().Pr_Interf
-#define MTO_AVG_GAP_BTWN_INTERF() MTO_DATA().AvgGapBtwnInterf
+#define MTO_AVG_IDLE_SLOT() MTO_DATA().AvgIdleSlot
+#define MTO_PR_INTERF() MTO_DATA().Pr_Interf
+#define MTO_AVG_GAP_BTWN_INTERF() MTO_DATA().AvgGapBtwnInterf
-#define MTO_CNT_ANT(x) MTO_DATA().Cnt_Ant[(x)]
-#define MTO_SQ_ANT(x) MTO_DATA().SQ_Ant[(x)]
-#define MTO_AGING_TIMEOUT() MTO_DATA().aging_timeout
+#define MTO_CNT_ANT(x) MTO_DATA().Cnt_Ant[(x)]
+#define MTO_SQ_ANT(x) MTO_DATA().SQ_Ant[(x)]
+#define MTO_AGING_TIMEOUT() MTO_DATA().aging_timeout
+#define MTO_TXFLOWCOUNT() MTO_DATA().TxFlowCount
-#define MTO_TXFLOWCOUNT() MTO_DATA().TxFlowCount
-//--------- DTO threshold parameters -------------
+/* --------- DTO threshold parameters ------------- */
#define MTOPARA_PERIODIC_CHECK_CYCLE() MTO_DATA().DTO_PeriodicCheckCycle
#define MTOPARA_RSSI_TH_FOR_ANTDIV() MTO_DATA().DTO_RssiThForAntDiv
#define MTOPARA_TXCOUNT_TH_FOR_CALC_RATE() MTO_DATA().DTO_TxCountThForCalcNewRate
@@ -133,13 +119,13 @@ struct wb35_mto_params {
#define MTOPARA_TXRATE_BACKOFF() MTO_DATA().DTO_TxRateBackOff
#define MTOPARA_TXRETRYRATE_REDUCE() MTO_DATA().DTO_TxRetryRateReduce
#define MTOPARA_TXPOWER_INDEX() MTO_DATA().DTO_TxPowerIndex
-//------------------------------------------------
+/* ------------------------------------------------ */
-extern u16 MTO_Frag_Th_Tbl[];
+extern u16 MTO_Frag_Th_Tbl[];
-#define MTO_DATA_RATE() MTO_Data_Rate_Tbl[MTO_RATE_LEVEL()]
-#define MTO_FRAG_TH() MTO_Frag_Th_Tbl[MTO_FRAG_TH_LEVEL()]
+#define MTO_DATA_RATE() MTO_Data_Rate_Tbl[MTO_RATE_LEVEL()]
+#define MTO_FRAG_TH() MTO_Frag_Th_Tbl[MTO_FRAG_TH_LEVEL()]
extern void MTO_Init(struct wbsoft_priv *);
extern void MTO_PeriodicTimerExpired(struct wbsoft_priv *);
@@ -148,6 +134,5 @@ extern u8 MTO_GetTxRate(struct wbsoft_priv *adapter, u32 fpdu_len);
extern u8 MTO_GetTxFallbackRate(struct wbsoft_priv *adapter);
extern void MTO_SetTxCount(struct wbsoft_priv *adapter, u8 t0, u8 index);
-#endif //__MTO_H__
-
+#endif /* __MTO_H__ */
--
1.7.0.3
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
