Patch to the adl_pci9118.c that fixes, ERROR: code indent should use tabs where possible, found by the checkpatch.pl tool Signed-off-by: Maurice Dawson <mauricedawson2699@xxxxxxxxxxxxxx> --- drivers/staging/comedi/drivers/adl_pci9118.c | 20 ++++++++++---------- 1 files changed, 10 insertions(+), 10 deletions(-) diff --git a/drivers/staging/comedi/drivers/adl_pci9118.c b/drivers/staging/comedi/drivers/adl_pci9118.c index 791ea83..9f30dee 100644 --- a/drivers/staging/comedi/drivers/adl_pci9118.c +++ b/drivers/staging/comedi/drivers/adl_pci9118.c @@ -44,20 +44,20 @@ c) If isn't used DMA then you can use only mode where Configuration options: [0] - PCI bus of device (optional) [1] - PCI slot of device (optional) - If bus/slot is not specified, then first available PCI - card will be used. + If bus/slot is not specified, then first available PCI + card will be used. [2] - 0= standard 8 DIFF/16 SE channels configuration - n= external multiplexer connected, 1<=n<=256 + n = external multiplexer connected, 1 <= n <= 256 [3] - 0=autoselect DMA or EOC interrupts operation - 1=disable DMA mode - 3=disable DMA and INT, only insn interface will work + 1 = disable DMA mode + 3 = disable DMA and INT, only insn interface will work [4] - sample&hold signal - card can generate signal for external S&H board - 0=use SSHO (pin 45) signal is generated in onboard hardware S&H logic - 0!=use ADCHN7 (pin 23) signal is generated from driver, number - say how long delay is requested in ns and sign polarity of the hold - (in this case external multiplexor can serve only 128 channels) + 0 = use SSHO(pin 45) signal is generated in onboard hardware S&H logic + 0 != use ADCHN7(pin 23) signal is generated from driver, number say how + long delay is requested in ns and sign polarity of the hold + (in this case external multiplexor can serve only 128 channels) [5] - 0=stop measure on all hardware errors - 2|=ignore ADOR - A/D Overrun status + 2 | = ignore ADOR - A/D Overrun status 8|=ignore Bover - A/D Burst Mode Overrun status 256|=ignore nFull - A/D FIFO Full status -- 1.6.3.3 _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/devel